Troubleshooting; Avant Chaque Utilisation - Hozelock Superhoze 8007 Manual Del Usuario

GB
Superhoze Quick Start Guide
• Fit the yellow tap connector onto your tap.
Use the white adaptor if required. (fig.1)
• Attach one end of your Superhoze to the tap connector.
(fig.2)
• Connect the nozzle to the other end of your Superhoze.
(fig.3)
Before each use
• Check that the connectors are tightened fully. (fig.4)
• Ensure the nozzle is fully open by turning it in a clockwise
direction, whilst pointed away from you. (fig.5)
• Turn the water on at the tap slowly. Allow water to run
through Superhoze for a few seconds to flush through any
trapped air. (fig.6)
• Close the nozzle fully by turning it in a counter clockwise
direction. (fig.7)
• Turn the water supply tap on fully. Watch as your Superhoze
expands. (fig.8)
• Once Superhoze has stopped expanding, open up your
nozzle and begin your watering tasks. (fig.9)
Once you have finished watering
• Turn off the water supply tap fully. (fig.10)
• Open the nozzle to release the water and allow Superhoze
to return to its original length. (fig.11) Ensure all water has
been drained from Superhoze. To prolong the life of your
Superhoze, drain water completely after each use and keep
indoors during the winter or during cold spells.
• Turn your Superhoze packaging into a storage device, by
making a hole in the bottom of the tub to allow any residual
water to escape. (fig.12) It is also suggested to leave the lid
off to aid ventilation.
Do's and Don'ts
Do:
• Soak the hose in water twice for a recommended
5-10 minute period before first use to reduce dye transfer.
• Make sure connectors are tight before each use.
(see figure 4)
• Hold the nozzle whilst emptying the hose of water after use
and dispose of waste water responsibly, by using it to water
your flowerbeds or pots.
• Connect Superhoze to a mains tap water supply - Superhoze
will not work if connected to a header tank or water butt.
Don't:
• Do not cut the hose.
• Leave the hose pressurised in direct sunlight.
• Stretch the hose without water.
• Allow the hose to freeze.
• Drink from the hose.
• Allow children to play with the hose.
• Expanding hoses are not recommended for use with
pressure or jet wash products.

Troubleshooting

Problem Solution
The hose is not Check that your nozzle or hose end is
expanding. closed fully.
Turn on water supply tap fully.
You may not have enough water
pressure at your property.
Connectors are Check that the connectors have been
leaking. tightened fully. (see figure 4)
Check that an O-ring is present and
in good condition on the end of the
nozzle and the tap connector.
If they are still leaking,
call Hozelock Customer Services.
Fabric has become Clean with warm, soapy water and
discoloured or leave to dry fully.
dirty.
The hose has Leave in open air to dry fully.
developed an
Clean with warm, soapy water and
odour.
leave to dry fully.
3 Year Guarantee*
*2 year guarantee + additional 1 year if you register online with
Hozelock. Terms and conditions apply:
www.hozelock.com/guarantee
F
Guide de démarrage rapide
• Montez le raccord de robinet jaune sur votre robinet.
Utilisez l'adaptateur blanc si nécessaire. (voir figure 1)
• Fixez une extrémité de votre Superhoze au raccord de
robinet. (voir figure 2)
• Branchez la buse à l'autre extrémité de votre Superhoze.
(voir figure 3)

Avant chaque utilisation

• Vérifiez que les raccords sont bien serrés. (voir figure 4)
• Assurez-vous que la buse est complètement ouverte en la
tournant dans le sens des aiguilles d'une montre, tout en la
dirigeant loin de vous. (voir figure 5)
• Ouvrez l'eau du robinet lentement. Laissez couler l'eau dans
votre Superhoze pendant quelques secondes pour évacuer
l'air emprisonné. (voir figure 6)
• Fermez la buse entièrement en la tournant dans le sens
inverse des aiguilles d'une montre (voir figure 7)
• Ouvrez complètement le robinet d'alimentation en eau.
Regardez votre Superhoze s'étendre. (voir figure 8)
• Une fois que votre Superhoze a cessé de s'étendre, ouvrez la
buse et commencez vos tâches d'arrosage. (voir figure 9)
Une fois que vous
avez terminé l'arrosage
• Fermez complètement le robinet d'alimentation en eau.
(voir figure 10)