DO NOT:
• Do not trim near drop-offs, ditches or
embankments. The operator could lose
footing or balance.
• Do not trim excessively steep slopes.
• Do not trim on wet grass. Reduced foot-
ing could cause slipping.
III. CHILDREN
Tragic accidents can occur if the opera-
tor is not alert to the presence of chil-
dren. Chil dren are often attracted to the
ma chine and the trimming activity. Never
assume that children will remain where
you last saw them.
• Keep children out of the trimming area
and under the watchful care of another
responsible adult.
• Be alert and turn machine off if children
enter the area.
• Before and while moving backwards,
look behind & down for small chil dren.
• Never allow children to operate the
machine.
• Use extra care when approaching blind
corners, shrubs, trees, or other objects
that may obscure vision.
Serial Number:
Date of Purchase:
Gasoline Capacity / Type:
Oil Type (API SJ–SN):
Oil Capacity:
Spark Plug (Gap: .020")
Trimmer Line Length:
• The model and serial numbers will be found on a decal on the rear of the trimmer.
Record both serial number and date of purchase in the space provided above.
PRODUCT SPECIFICATIONS
1.6 Quarts (Unleaded Regular)
SAE 30 (above 32°F); SAE 5W-30 (below 32°F)
15.5 Ounces
Autolite 3924
18.75 Inches (0.155 Inch Diameter)
4
IV. SERVICE
• Use extra care in handling gasoline and
other fuels. They are flammable and
vapors are explosive.
- Use only an ap proved con tain er.
- Never remove gas cap or add fuel with
with the engine running. Allow engine
to cool before refueling. Don't smoke.
- Never refuel the machine in doors.
- Never store the machine or fuel
con tain er inside where there is an
open flame, such as a water heater.
- Move away from fueling site before
starting engine.
• Never run trimmer inside a closed area.
• Never make adjustments or repairs with
the engine (motor) running. Disconnect
the spark plug wire, and keep the wire
away from the spark plug to prevent ac-
ci den tal starting.
• Keep nuts and bolts, especially trimmer
head and engine bolts, tight and keep
equipment in good condition.
• Never tamper with safety devices.
Check their proper operation regularly.
• Keep machine free of grass, leaves, or
other debris buildup. Clean oil or fuel
spillage. Allow machine to cool before
cleaning or storing.
• Stop and inspect the equipment if you
strike an object. Repair, if necessary,
before restarting.
• Do not change the engine governor set-
ting or overspeed the engine.
• Clean and replace safety and in struc tion
decals as necessary.