Install The Hardware; Mount The Camera - Axis Communications 209FD Installation Guide

Page 6

Install the hardware

! IMPORTANT! - The casing of the AXIS 209FD/AXIS 209MFD is not approved
for outdoor use and may only be installed in indoor environments.

Mount the camera

The AXIS 209FD//MFD can be mounted with the cable routed through the ceiling or from the
side.
The AXIS 209FD/AXIS 209MFD is
supplied with a standard RJ-45 female
network connector, on a 2 meter cable.
1. Using the supplied allen/hex key,
loosen the 4 screws holding the cover
and remove it.
2. Use the base plate to mark out the
positions for the mounting screws.
3. To route the cable through a ceiling,
cut or drill the hole for the cable and
connector.
For the AXIS 209FD/AXIS 209MFD
- cut a 17mm hole.
For the AXIS 209MFD - cut a 30mm
hole.
AXIS 209FD//MFD Installation Guide