This is used on Ultima 100 models to properly balance your spotting scope on top of a photo/video tripod.
¼"-20 Threaded Hole
(not shown)
To use the tripod balancing platform:
Mount the platform to the top of your photo tripod using the ¼"-20 threaded hole on the bottom side of the platform.
Attach your spotting scope to the platform using the ¼"-20 mounting screw located on the top side of the platform. Thread the mounting screw in as far as it
will go. Slide the attached spotting scope along the slotted cutout until your spotting scope is balanced on the tripod.
Tighten the locking ring to hold the spotting scope in place.
Maintenance
To protect your spotting scope when not being used, put on all lens covers and the lens cap to keep the optics clean and then put
the scope in the soft carrying case. If your optics could use cleaning, use an optics cleaning kit and follow the instructions.
Model
52248
Description
Ultima 65
Viewing Position
45° Angled
Aperture - mm
65
Focal Length - mm
386
Magnification
18x-55x
Eyepiece - Zoom
7-21mm
Angular Field
1.7° @ 18x
of View
0.7° @ 55x
Linear Field of View
89 @ 18x
- feet @ 1000 yds.
38 @ 55x
18mm @
Eye Relief
18x
Near Focus
20ft @ 18x
6.1m @ 18x
Prisms - BaK - 4
Yes
Multi-
Optical Coatings
Coated
Waterproof
Yes
13" -
Length
330mm
37oz. -
Weight
1.1kg
Note: All specifications are subject to change without notice.
Warranty
Ultima Spotting Scopes have the Celestron No Fault Limited Lifetime Warranty for the U.S.A. and Canadian customers. For
complete details of eligibility and for warranty information on customers in other countries visit the Celestron website.