Operation; Emergency Procedures - BriskHeat SRL-ADJ Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

OPERATION

SRL-ADJ and SRP-ADJ series:
This product is equipped with a dial adjustable thermostat temperature controller. A maximum
temperature is identified on the label: 425°F (218°C) or 160°F (71°C). Adjust dial to desired heat output .
To increase temperature output of the heater, turn the adjustable dial in the clockwise direction. To
decrease temperature output of the heater, turn the adjustable dial in the counter clockwise direction.
Note:
Ambient conditions will affect the dial's position in which the heater begins to heat. In cooler
temperature conditions the heater will begin to heat at a lower temperature position on the dial
and in warmer temperature conditions the heater will begin to heat at a higher temperature
position on the dial.
It is recommended that a thermometer is attached to the vessel being heated. Adjust the dial until you
achieve the desired temperature.
Note:
Changes in ambient conditions or in the temperature of the contents may cause the
temperature to shift over time.
For heating temperature sensitive materials that require a specific set-point or have a tight
tolerance temperature range Use of an external temperature controlling device is required. Select a
temperature controller with the accuracy necessary for the application and is approved for the location
and conditions where the heater is to be used. For lower temperature applications up to 212°F (100°C)
BriskHeat recommends the use of a TC4X Digital Temperature Controller. For higher temperature
applications BriskHeat recommends the use of a TTD Digital Temperature Controller.
Note:
If assistance determining a proper temperature controlling device is required for your
application, please contact BriskHeat or your local distributor for application assistance and
product solutions.
Install and connect the external temperature controlling device between the heater and the electrical
source as shown in Figure 3. Install the temperature controlling device in accordance with
manufacturer's installation instructions.
Ensure a grounded connection is provided and if the temperature controlling device does not support a
grounded connection, ensure an approved earth ground source is provided.
Mount the temperature sensor on the surface being heated near the heater. Secure the sensor using
appropriately rated aluminum or fiberglass adhesive tape.
Set the heater's temperature controlling dial to the maximum temperature setting. Adjust heater output
using the external temperature controlling device.
Electrical
External Temperature
Source
Controlling Device
Controller Power Connection
®
© BriskHeat
Corporation. All rights reserved.
SRL-ADJ & SRP-ADJ
Silicone Rubber Heating Blankets
Temperature
Sensor
Heater
Heater Power Connection
Figure 3
7

EMERGENCY PROCEDURES

Read and understand these procedures prior to using this heater.
Disconnect power to the heater in the event of an emergency.
Electric Shock:

Do not touch the injured person while they are still in contact with the electrical current.

Call your local emergency service if the injured person experiences: severe burns, confusion,
difficulty breathing, heart rhythm problems, cardiac arrest, muscle pain and contractions, seizures
or a loss of consciousness.
Minor Burns:

Hold the burned area under cool running water for 10-15 minutes.

Remove rings or other tight items from burned area.
Major Burns:

Call your local emergency service.

Protect the person from further harm.

Remove rings or other tight items from burned area.

Monitor breathing and perform CPR if necessary.
Fire:

Call your local emergency service.

If it is safe to do so, use a fire extinguisher to fight the fire, otherwise evacuate to a safe distance
and wait for help to arrive.

This heater is built from material that will not support a flame but could ignite nearby combustible
material.
®
© BriskHeat
Corporation. All rights reserved.
SRL-ADJ & SRP-ADJ
Silicone Rubber Heating Blankets
8

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Srp-adj

Tabla de contenido