End Of A Charge / Discharge Process; Display Of The Charge / Discharge Data - ROBBE Power Peak QUAD EQ-BID Manual Del Usaurio

While charging or discharging, the most important data is stored on the chip/key.
10.

END Of A chARGE / DISchARGE PROcESS

The processor always employs the ideal process by taking the charge parameters into
account, with the result that the unit automatically terminates the charge or discharge
process exactly at the right moment. The charger always employs the optimum process
for each battery type.

10.1 DISPLAy Of ThE chARGE / DISchARGE DATA

During a charge or discharge processthe values for that process are constantly shown in
Charged or
Status indicator
discharged
Flashing 'F'
capacity
(Finish)
Current battery
Battery
voltage
type
Operating Instructions
Power Peak ® Quad EQ-BID
First connect the BID chip / KEY to the charger
using the adaptor lead. This automatically causes
the screen display shown here to appear.
If the charge parameters on the chip are accep-
table, press the 'ENTER' button to prepare the
process. From this point on, the procedure is iden-
tical to a normal process initiated from a battery
memory;the sequence is described in Chapter 7.4.
Charge/dis-
charge time
Charge or
discharge
current
the working display (see Chapter5.1).
If the process concludes successfully, the
charger alerts you with an audible beep.
The screen now displays the essential
data relating to that process, as shown
inthe adjacent illustration.
19
Order No.
8565