Select Direction Of Rotation; Switching On And Off; Preselecting Rotational Speed; Maintenance And Cleaning - Parkside PBH 1050 C3 Traducción Del Manual De Instrucciones Original

Adjusting chisel position
You can rotate the tool to the required position for
chiselling using this function.
♦ Turn the function selector switch
position .
♦ Turn the tool in the tool holder
required position.
♦ Turn the function selector switch
position for the chiselling function.

Select direction of rotation

♦ Select the direction of rotation by adjusting the
right/left rotation switch
WARNING!
► The right/left running switch
be used/adjusted if the appliance is at a
standstill.
Switching on and off
Switching the appliance on
♦ Press the ON/OFF switch
Switching the appliance off
♦ Release the ON/OFF switch
Switching to continuous operation
♦ Press the ON/OFF switch
pressed position with the ON/OFF switch lock
button .
Switching off continuous operation
♦ Press the ON/OFF switch
again.
PBH 1050 C3
to
to the
to
.
may only
.
.
. Lock it in the
and release it

Preselecting rotational speed

You can use the speed preselector wheel
preselect the rotational speed. Level 1 (low rota-
tional speed) up to level 6 (high rotational speed).
The speed you select depends on the material to
be processed. Work out the right setting with this
practical test:
- Levels 4 – 6: high rotational speed:
for hammer drilling/chiselling in concrete or
stone.
- Levels 1 – 3: medium rotational speed:
for drilling in steel or wood.
NOTE
► The set speed is only reached in continuous
operation.

Maintenance and cleaning

WARNING! RISK OF INJURY! Switch
the appliance off and remove the
power plug before starting any work
on the appliance.
■ Never permit liquids to enter inside the appliance.
■ Use a soft, dry cloth to clean the housing.
■ Clean the tool holder
CAUTION! PRELOADING!
♦ To do this, pull the locking collar
and pull the dust protector cap
holder .
♦ Before fitting a tool into the tool holder
grease it lightly.
WARNING!
► If the power cord requires replacement, this
should be carried out by the manufacturer or
an approved representative to avoid safety
hazards.
NOTE
► Replacement parts not listed (such as carbon
brushes, switches) can be ordered via our
service hotline.
to
regularly:
backwards
off the tool
,
GB │ MT │
43 ■