Rear Panel - Hartke KILO Manual Del Propietário

Kilo • 1000 Watt Bass Amplifier
1
2 3 5 6
1. Voltage Selection Switch – This switch is used to set the Kilo operation voltage.
Be sure to check that the switch is set correctly for your country.
2. AC Inlet – Connect the supplied standard 3-pin "IEC" plug here. You should never
remove the ground pin of the AC plug.
3. Fuse – This contains the fuse for your amplifier. Be sure to confirm and install the
properly rated fuse when replacing. Fuse ratings are 15 amp for 115 vac and 8
amp for 230 vac.
4. LEFT SPEAKER OUTPUTS – Use these outputs to connect speakers to the left am-
plifier output. The amplifier provides both ¼" and Speakon® output connectors,
wired in parallel. It is recommended to use the Speakon® jack whenever possible.
The total impedance of the speakers connected to all of the jacks must not be less
than 2 ohms.
5. RIGHT SPEAKER OUTPUTS – Use these outputs to connect speakers to the right
amplifier output. The amplifier provides both ¼" and Speakon® output connectors,
wired in parallel. It is recommended to use the Speakon® jack whenever possible.
The total impedance of the speakers connected to all of the jacks must not be less
than 2 ohms.
6. MONO BRIDGE OUTPUTS – Connect a Speakon® connector cable here when
operating in Bridge mode. The total impedance load of the speakers connected to
the output must not be less than 4 ohms.
7. STEREO/MONO BRIDGE Switch – This switch is used to set the amplifier to oper-
ate in either Stereo or Mono Bridge mode.
8. MUTE+OVERDRIVE FOOTSWITCH – Connect a two-button footswitch, terminat-
ing to a ¼" TRS connector (Tip = MUTE, Ring = OVERDRIVE) to this jack to control
the MUTE and OVERDRIVE select switches. The front panel switch is disengaged
when the footswitch is plugged in.
4 8
7 9
10 11 12
15 16
13 14 18

Rear Panel

17
19
11