Anywhere Programming; Memory Protection; Rain Sensor Operation; Important - Toro Turf Pro Serie Guia Del Usuario

"Anywhere Programming"

The Turf Pro control module is designed
to be easily removed for complete
programming in a more convenient
setting, or for servicing. The battery
keeps the current time and allows
changes to settings until the module is
connected to AC power.
To remove the module, pull forward on
the right edge of the module as if you
were going to replace the battery. Unplug
the ribbon cable connector from the
printed circuit board, as shown in Figure
1, then unsnap the module from it's
hinges. To reinstall the module, simply
reverse the order of the removal steps.

Memory Protection

Program settings are stored in a unique electronic device called "non-
volatile" memory and retained for up to 10 years even without battery power.
A new battery maintains the current date and time for 48 hours.

Rain Sensor Operation

A two-position sensor switch (as shown in Figure 1 above) is provided to
bypass the (optional) rain sensor function if necessary.
IMPORTANT: If a rain sensor is NOT connected to the controller,
the sensor switch must be in the BYPASS position or the jumper
wire attached to both sensor terminals to enable controller
operation. The controller will not operate automatically if the sensor
switch is in the ACTIVE position without a sensor or jumper wire
installed.

Remote Control Compatibility

Turf Pro controllers are "Remote Ready." The optional EZ-Remote system
allows remote activation of the controller from as far as 160 to 300 feet away.
The EZ-Remote, connected to your Turf Pro controller allows you to
remotely run the valves while out in your yard or garden for system
"checkout", fall air "blowout" in freeze-prone areas or system
troubleshooting.
Figure 1
Rain Sensor Switch
Ribbon Cable
3