Installation Instructions; Antenna Installation - PNI Escort HP 8000L Manual De Usuario

MICROPHONE DESCRIPTION:
2 3 4
UP ASQ DOWN
1

INSTALLATION INSTRUCTIONS:

Before installing the radio in your vehicle, choose the most suitable location so you can use it without being
disturbed while driving.
To install the radio, use the mounting bracket and accessories in the package. The screws must be securely
clamped to avoid vibration of the station while driving. The mounting bracket can be positioned above or below
the device and can be tilted depending on the installation mode (under the dashboard or under the truck cabin
ceiling).
WARNING: Ensure that the voltage at which the station is powered is the voltage indicated by the manufacturer.
Installation of the central unit:
Before powering the radio, make sure that the power button is fully turned to the left.
The power cord of the station includes a protective fuse on the red wire. Connect the radio's power cable to
the car's electrical system paying attention to the polarity (even if the radio has protection against polarity
reversal).
Connect the red wire to the positive terminal (+) and the black wire at the negative terminal (-) of the vehicle's
electrical system.Check the connections made correctly to prevent them from being disconnected or possibly
short-circuiting.
WARNING: Do not replace the fuse with a higher value. The fone from the actory has 2A.

Antenna installation:

To use this radio, you need an antenna that operates at 27.225MHz.
To install the antenna, call a specialist.
Before connecting the antenna to the radio, it is necessary to check it with a specialized device to prevent the
transmission circuit failure.
1. PTT button – Push to Talk
2. Increase channel number
3. Enable / disable ASQ function
Decrease channel number
4.
5
EN