Homak PROFESSIONAL Serie Guía De Utilización Y Directivas De Funcionamiento página 4

Ocultar thumbs Ver también para PROFESSIONAL Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY
* We recommend that TWO PEOPLE work together on the assembly,
due to the weight of this cart. Cart weight is approximately 170 lbs,
please be careful during assembly.
1.Locate the key tied to the bottom tray. Using the key, open the lid and
remove the caster box from the bottom drawer. After removal, make sure
all drawers are completely closed and the inside lever is in the locked
position. Close and lock the top lid.
2. Using the protective foam provided, lay out a work surface. Gently turn
the cart onto its lid on top of the foam surface.
3. (Before assembling the legs remove the cable
tie holding the bumper in place). Insert the front leg
(Part E), labeled FL or FR into top lip of the cart.
Then place the Front bumper (Part F) over the leg
aligning the center bolt holes. With holes aligned
insert stove bolt (Part G) and finger tighten with
washer, spring washer, and then the nut.
4. Install back leg (Part E) labeled BL or BR and
bumper (Part F) following the same procedure as
above. Note: Make sure the back leg is inside the
hinge rivet. Otherwise the holes will not line up
during assembly.
5. Repeat steps 3 & 4 to mount the legs on the
opposite side.
6. Completely tighten the 8 bolts just inserted.
7. Insert bottom shelf (Part H) between the four
legs flat side facing up towards the ceiling. In-
sert sixteen stove bolts. (Part G) and completely
tighten.
8.Mounting casters: Put the four casters (Part C)
in place. The two locking casters should be on one
side of the cart and the two non locking casters
should be on the other (Left or right side NOT front
or back). Using the 16 bolts (Part D), washers
- 2 -
Step 4
Step 6
Step 7

Publicidad

Tabla de contenido
loading

Productos relacionados para Homak PROFESSIONAL Serie

Este manual también es adecuado para:

Bk06032000

Tabla de contenido