Seac LUCE Guia De Inicio Rapido página 17

If the battery has not been installed properly (polarity inversion), a short
circuit will damage the equipment, with a serious risk of an explosion.
CHECKS BEFORE DIVING
• If the torch has not been recently used, check the state of the LUCE/
LUCE LED torch batteries and switch on the torch to test.
• Check for the perfect seal of the body.
• When under water, check that there is no continuous discharge of air bubbles
from the torch body.
FLOODING
In case of water leakage into the torch, open it, remove the batteries and rinse
immediately the internal parts in fresh water, then wipe with a cloth and dry
with a warm air source, paying particular care to mechanical parts. Remove
the oxide, if any, deposited on metal parts and test for correct operation.
If the quantity of water leaked into the torch is considerable and if it has
remained there for a long time, open the torch and rinse immediately the
internal parts in fresh water; in such occurrence immediately contact a
suitable servicing centre or the nearest SEAC centre.
LIMITS OF USE
• The maximum operating depth is 100 m.
• Owing to the high temperatures reached by the bulb, the lamp should be
used only under water.
BULB REPLACEMENT (ONLY LUCE VERSION)
• Unscrew the lens ring nut.
• Extract the bulb to be replaced and insert the new one as shown by the two
small arrows on the reflector holder.
• Reinsert the whole assembly making sure that the bulb fits in the reflector hole.
• Lubricate threaded parts and O-rings, then screw the lens ring nut.
MAINTENANCE AND TRANSPORT
Compliance with the following instructions is required:
• Always carry the torch inside a bag protecting it from any shocks.
• Avoid prolonged exposure to sunrays.
054-MANUALE LUCE-LUCE LED.indd 15

WARNING
English 15
06/11/2009 9.48.30