Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
B. Lubrication
Threaded joints should be well-lubricated with petroleum or a soap-thickened mineral oil. If
corrosive products have accumulated on joints and cannot readily be removed with solvents, the
parts should be discarded and replaced.
Never use an abrasive material or file to remove corrosive products from
threaded surfaces. In extremely corrosive locations, equipment should be
periodically inspected to guard against unusual deterioration and possible
porosity, since this may weaken the enclosure structurally.
C. Service
The Federal Signal factory will service your equipment or provide technical assistance with any
problems that cannot be handled locally.
Any units returned to Federal Signal for service, inspection, or repair must be accompanied
by a Return Material Authorization. This R.M.A. can be obtained from the local Distributor or
Manufacturer's Representative.
At this time a brief explanation of the service requested, or the nature of the malfunction, should
be provided.
Address all communications and shipments to:
Table 1.
Hazardous
Environment
Class I,
Division 2
Class II,
Groups E, F, G
Class III
FEDERAL SIGNAL CORPORATION
Industrial Systems
Service Department
2645 Federal Signal Drive
University Park, IL 60484-3167
708-534-4858 (Service)
708-534-3424 ext 5823 (Technical Assistance)
Max. Temperature/
T-Code at 40°C
Ambient
135°C/T4
100°C/T5
100°C/T5
WARNING
Light
Electrical
Output
Ratings
17 cd
24 Vdc
(with
(regulated):
Guard)
16 Vdc to
33 Vdc,
0.483 A to
0.226 A
25 cd
(without
Guard)
-3-
Flash
Operating
Rate
Temperature
60 per
–67ºF to 104ºF
minute
(–55ºC to
40ºC)
Publicidad
Tabla de contenido
