S&P HA-600 Manual De Instalacion E Instrucciones De Uso página 12

2.2.- Fastening the hood
 The hood must be centred with respect to the cooking surface, at a minimum height of
650 mm.
 Use screws and plugs, but first make sure that they are correct for the type of wall
where the hood is to be fitted.
 Before setting Operations, remove the filter panels (Fig.5).
 Drill 4 holes A-B of Φ 6, shown in (Fig.3).
 Insert plugs and screws (Fig.3-A) without tightening completely, in such a manner that
the hood can be supported from them.
Then attach the Hood body to the wall using two internal screws. (Fig.3-B).
 Fix the decorative telescopic support in the wall (Fig. 4). Make sure all screws are tight.
Extraction version:
 Using a joining pipe of diameter 150mm, connect output ring (Fig.6) and the discharge
opening. Secure the connection joints, to avoid air leaks, with self adhesive tape.
 Fix the upper part of the telescopic decorative cover with the support by two lateral
screws (Fig.6-B)
Extend the lower part of the telescopic decorative cover and attach to the hood body

using the inner screws. (Fig.6-A).
Filter version:
 If your installation does not have a discharge opening to the outside, you will have to
ask your supplier for two S&P active circular carbon filters of diameter 130mm,
which are supplied as an accessory and are not included as standard equipment. To
mount them, see (Fig.7).
Fix the plastic bracket to the wall just below the decorative telescopic support (Fig.8).

The two pins of the support position have to fit with the holes of the plastic derivation.
 You can easily cut the plastic shunt (Fig.9) to fit well inside the top of the telescopic
cover and the air outlets are properly aligned with the exhaust grill.
 Using a joining pipe of diameter 150 mm, connect output ring and the plastic shunt.
Secure the connection joints to avoid the air leaks, with self adhesive tape. (Fig.10).
 Fix the lower part of the telescopic decorative cover to the support by two inner
screws (Fig.10-A).
 Extend the top of the telescopic cover and secure it to lateral screws (Fig.10-B).
12