Black and Decker NV24XXYZ H2 Manual Del Usuario página 7

Read the manual carefully
before using the appliance.
Warning! Keep electrical appliances out
of reach from children or infirm persons.
Do not let them use the appliances
without supervision.
Features
1. On/off switch
2. Dust bowl
Fig. A
3. Crevice tool
4. Brush tool
Unpacking
Identifying your product
The model design can be determined
from the suffix codes used in the
catalogue number. The following
catalogue numbers are described in this
manual: NV19XXYZ H2/NV24XXYZ H2/
NV36XXYZ H2/NV48XXYZ H2/
NV60XXYZ H2/NV72XXYZ H2
The suffix code XX corresponds to the
following designs:
00/99: stick handle, no accessories
supplied
03: loop handle, supplied with crevice
tool and brush tool
The suffix code Y is used to identify the
range of colour, print or special options.
The suffix code Z represented by the
letter N is used for models with an NiMH
battery.
Installation
NV24XXYZ/NV36XXYZ/NV48XXYZ/
NV60XXYZ/NV72XXYZ - Fitting the
charging base to the wall
(fig. B1 & B2)
The charging base can be placed on a
worktop or fitted to the wall to provide a
convenient storage and charging point
for the appliance.
ENGLISH
Assembly
Fitting the accessories (fig. A & C)
Depending on the model, the appliance
is supplied with the following accessories:
a crevice tool (3) for confined spaces
u
a brush tool (4) for furniture and stairs
u
To fit an accessory, proceed as follows:
Take the accessories from the
u
appliance.
Insert the appropriate accessory into
u
the front of the appliance.
You may refit the other accessory by
clicking it into the accessory holder.
To refit both accessories:
Push the accessories down until they
u
click into place.
Use
The appliance can be charged while
u
placed on a worktop or hung on the
wall using the wall hook provided.
Before first use, the battery must be
u
charged for at least 24 hours.
Leave the appliance connected to the
u
charger whenever it is not in use.
Charging the battery (fig. B1 - B3)
NV24XXYZ/NV36XXYZ/NV48XXYZ/
NV60XXYZ/NV72XXYZ (fig. B1 & B2)
Make sure that the appliance is
u
switched off. The battery will not be
charged with the on/off switch in the
on position.
Fit the appliance properly on the
u
charger aligning the arrow on the
charger with the split of the appliance.
Plug in the charger.
u
Switch on at the mains.
u
Leave the appliance to charge for at
u
least 24 hours.
NV19XXY (fig. B3)
Make sure that the appliance is
u
switched off. The battery will not be
charged with the on/off switch in the
on position.
Insert the charger plug (6) into the
u
charger connector (7) at the rear of
the appliance.
7