Publicidad
Please read the operating instructions BEFORE operating the machine.
Our warranty/product responsibility requires that:
•
instructions are followed, and that no conversion or modification is carried out.
•
original spare parts, and hydraulic oils and lubricants recommended by the machine manufacturer
are used.
•
at least one annual service is carried out.
The user of the machine is responsible for the safety checks, and for ensuring that daily maintenance of the
machine is carried out. The user is responsible for seeing to it that defects are rectified, and that neither the user
The owner is responsible for ensuring that all laws and instructions are complied with when using the machine.
This symbol means WARNING or DANGER - PERSONAL SAFETY INSTRUCTION.
The ORWAK 9020 is designed for ONE MAN OPERATION. ONLY THE OPERATOR IS
ALLOWED IN THE WORKING AREA. Only trained operators are allowed to use the machine.
Materials easily to set on fire or of an explosive nature, such as cans with residual low flash
point liquids, or anything which could cause damage or explosion must not be compacted in
the ORWAK 9020 baler.
The machine must not be used if the safety functions have been interfered with such
as the opening of the head covers or limit switches.
The gas spring at the rear of the machine must not be exposed to high temperatures
such as welding.
The machine must not be used by under age persons.
Do not climb on the machine.
During cleaning, maintenance and service the main switch always must be turned to zero and
locked in this position with a padlock to prevent unauthorized or unintentional start of the machine.
Always use both hands to pull the press unit to the next chamber and only load within
100 mm from the top of the chamber. DO NOT OVERLOAD.
The machine has a high centre of gravity. The press plate must be fully lowered when the
machine is moved.
The machine may only be operated by a person who has received training and has
experience of the machine.
The machine is equipped with the following safety features :
The Main switch can be secured with a pad lock to prevent unauthorised use or when servicing, cleaning or
maintaining the machine.
The Emergency Stop Switch breaks the electrical circuit immediately it is used. When the switch is reset the
machine will not restart. The start button has to be pressed again. The press plate always returns upwards to a
safe position.
Mechanical and electrical limit switches prevent the machine being used with the covers open or when the
press head is moved between chambers.
The machine can not be operated with the doors open as mechanical protection prevents this.
There are protective cover over the bale ejection mechanism at the rear of the chambers.
The electrical circuits of the machine are protected by a circuit breaker which also serves to protect the motor.
Under voltage protection is provided to prevent the machine from starting after a power failure.
The
is an hydraulically driven baler used mainly to reduce the volume of bulky materials such
ORWAK 9020
as paper, plastic and light wooden boxes. The machine is intended for use within the temperature range
-10°C to +40°C. A low-temperature oil and/or heater should be used at temperatures lower than +5°C.
Materials easily to set on fire or of an explosive nature, such as cans with residual
low flash point liquids, or anything which could cause damage or explosion must not
be compacted in the
9020
GB
SAFETY INSTRUCTIONS
nor other persons are subjected to danger.
SAFETY FEATURES
RANGE OF APPLICATION
baler.
ORWAK 9020
4
Publicidad
