General Specifications - Paul Mitchell NEURO DRY Guia Del Usuario

GENERAL SPECIFICATIONS

Frequency (Hz): 50/60Hz • Rated Wattage: 2000 W
Model Rated Voltage
NDEA Europe 220-240VAC
*United Kingdom: fitted with a converter plug in compliance with UK BS1363
Length of A.C. Cord: 9 ft. (2.7 m)
Weight: 680 g
This appliance complies with the requirements of Directives 2004/108/EC
(Electromagnetic compatibility) and Directive 2006/95/EC (Low Voltage).
OPERATING INSTRUCTIONS
On / Off
Button
SmartSense
Filter Reset Button
Increase Decrease
Button
Button
PRESS THE POWER BUTTON to turn on the hair dryer. The temperature/
speed bar, logo, and "Clean Filter" will light up.
USE AND BUTTONS TO:
• Increase the temperature and airflow
• Decrease the temperature and airflow
3
NDEA_book_F13_FINAL_v3.indd 3-4
Plug Type
C (2 pin euro)*
Temperature/
Speed Bar
FILTER
SmartSense
"Clean Filter" light
PRESS THE COOL SHOT BUTTON TO RELEASE COOL AIR. Release
the cool shot button to return to heating.
SMARTSENSE "CLEAN FILTER" LIGHT
After 100 hours of use, the SmartSense "Clean Filter" light will begin to blink
to alert you to wash and clean the filter (remove and thoroughly wash filter
with warm water and air dry). Hold firm on both sides of filter rubber tabs
(back of dryer) and firmly pull. Remove the mesh filter and run under warm
water to clean; completely air dry before use. Press the reset button for
approximately 5 seconds to reset the filter button and reset for another 100
hours. The "Clean Filter" light will stop blinking once reset.
PRESS THE POWER BUTTON to turn off the hair dryer.
OVERHEATING
If overheating occurs, an automatic safety device will turn the dryer off. If
this occurs, unplug the cord and allow the dryer to cool for 10 to 15 minutes.
Make sure the air vents and filter are fully cleaned before starting again.
DEFECTS AND MALFUNCTION
• In case some malfunction is found, consumers can return the dryer
to the salon where it was purchased; salons/stylists can return it to
their distributor.
• Read all contents of the warranty completely and carefully before
contacting the salon or the distributor.
• John Paul Mitchell Systems® is not responsible for damage caused
by misuse or due to operator accidents, such as dropping the
appliance on the floor.
4
9/13/13 2:03 PM