DJI T20 Intelligent Flight Battery Guia Del Usuario página 5

• DO NOT use a battery that has been dropped. Dispose of the battery as described in the Battery
Disposal section.
• If the battery falls into water while inside an aircraft during flight, take it out immediately, and put it
in a safe and open area. DO NOT use the battery again and dispose of it properly as described in
the Battery Disposal section.
• DO NOT put the battery in a microwave oven or a pressurized container.
• DO NOT place the battery on or near wires or other metal objects such as eyeglasses, watches,
jewelry, and hairpins. Otherwise, the battery ports may be short-circuited.
• DO NOT drop, strike, pierce, disassemble, or manually short-circuit the battery. Otherwise, it may
leak, catch fire, or explode.
• Always use a clean, dry cloth when cleaning the battery terminals.
• DO NOT fly when the battery power level is below 15%.
• Make sure the battery is correctly connected. Otherwise, the battery may overheat or even
explode due to abnormal charging. Only use approved batteries from authorized dealers. DJI
assumes no responsibility for any damaged caused by using batteries that are unapproved.
• Make sure to lift the battery by the handle. DO NOT lift it by holding the cables.
• Make sure the battery is placed on a flat surface.
• DO NOT place anything on a battery. Otherwise, the battery may be damaged, which may lead
to fire hazards.
• The battery is heavy. Be careful when moving the battery to avoid dropping it. If the battery is
dropped and damaged, immediately leave the battery in an open area away from people. Wait
30 minutes and then soak the battery in water for 24 hours. After making sure the power has
completely ran out, dispose of the battery in accordance with local laws.
• Put out any battery fire using sand or a dry powder fire extinguisher.
• Make sure the battery is fully charged before each flight.
• Immediately land the aircraft if a critical battery level warning appears and replace with a fully
charged battery.
• Before operating in a low-temperature environment, make sure the battery is at least above
5° C (41° F). Ideally, above 20° C (68° F).
LED Patterns
Battery Level LED Patterns
LED is on
LED is off
Checking Battery Level
If the battery is in power saving mode, press the power button once to check the current battery level.
LED1 LED2
4
LED is blinking
LED3 LED4 Battery Level
88% - 100%
75%~87%
63%~74%
50%~62%
38%~49%
25%~37%