External Connections - PICO PicoScope 6000E Serie Guia Del Usuario

PicoScope 6000E Series oscilloscopes

2.4 External connections

To prevent injury or death, use only the power cord and adaptor supplied with the product. These are approved for
the voltage and plug configuration in your country. The power cord is fitted with a three-pin plug and must always
be connected to a grounded power socket.
External DC power supply
All models
Take care to avoid mechanical stress or tight bend radii for all connected leads, including all coaxial leads and
connectors. Mishandling will cause deformation and will degrade performance and measurement accuracy.
2.5 Environment
This product is suitable for indoor or outdoor use, in dry locations only. The product's external mains power supply is
for indoor use only.
To prevent injury or death, do not use in wet or damp conditions, or near explosive gas or vapor.
To prevent damage, always use and store your oscilloscope in appropriate environments.
Temperature
Humidity
(non-condensing)
Altitude
Pollution degree
2.6 Care of the product
The product contains no user-serviceable parts. Repair, servicing and adjustment require specialized test equipment
and must only be performed by Pico Technology or an approved service provider. There may be a charge for these
services unless covered by the Pico five-year warranty.
Inspect the instrument and all probes, connectors, cables and accessories before use for signs of damage.
To prevent electric shock do not tamper with or disassemble the oscilloscope, case parts, connectors or
accessories.
6
WARNING
Voltage
12 V
CAUTION
WARNING
CAUTION
Storage
–20 to +60 °C
5 to 95 %RH
EN 61010 pollution degree 2: "only non-conductive pollution occurs except that
occasionally a temporary conductivity caused by condensation is expected"
WARNING
Copyright © 2020–2021 Pico Technology Ltd. All rights reserved.
Current
Oscilloscope only
5 A pk
Operating
0 to 40 °C
5% to 80% RH
Up to 2000 m
User's Guide
Oscilloscope + powered
accessories
7 A pk
Quoted accuracy
15 to 30 °C after 20
minutes' warm-up
DO338-5