Attaching The Fan Blades - HAMPTON BAY 526 012 Manual Del Propietário

Step 1 Connect the fan supply (black) wire to
the black wire from the wall control as shown
in Figure 8.
Step 2 Connect the neutral fan (white) wire to
the white neutral household wire.
Step 3 Connect the two green fan ground wires,
located on the downrod and mounting bracket,
to the household ground wire.
Step 4 After connecting the wires, spread them
apart so that the green and white wires are on
one side of the outlet box and the black wire is
on the other side.
Step 5 Turn the wire connecting nuts upward
and push the wiring into the outlet box.
EACH WIRE NUT (WIRE CONNECTOR) SUP-
PLIED WITH THIS FAN IS DESIGNED TO ACCEPT
UP TO ONE 12 GAUGE HOUSE WIRE AND TWO
WIRES FROM THE FAN. IF YOU HAVE LARGER
THAN 12 GAUGE HOUSE WIRING OR MORE
THAN ONE HOUSE WIRE TO CONNECT TO THE
FAN WIRING, CONSULT AN ELECTRICIAN FOR
THE PROPER SIZE WIRE NUTS TO USE.
6.
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK, AND/OR PERSONAL INJURY, WIRE ONLY
A SINGLE WALL-CONTROL PANEL/SWITCH AND
CEILING FAN UNIT TOGETHER. WIRING TWO
OR MORE CEILING FANS TO ANY SINGLE WALL-
CONTROL PANEL SWITCH MAY CAUSE THE CIR-
CUITRY TO FAIL BY OVERHEATING. PLEASE DO
NOT ATTEMPT TO DEFEAT THIS FEATURE OF
THE CEILING FAN SYSTEM AS DOING SO WILL
VOID THE WARRANTY, BOTH EXPLICIT AND IM-
PLICIT STIPULATIONS THEREOF.
LOCKING SLOTS OF CEILING CANOPY ARE
PROVIDED ONLY AS AN AID TO MOUNTING. DO
NOT LEAVE FAN ASSEMBLY UNATTENDED UN-
TIL ALL FOUR CANOPY SCREWS ARE ENGAGED
AND FIRMLY TIGHTENED.
Attaching the
Fan Blades
NOTE: The blade and blade arms are pre-as-
sembled together at the factory. The blades are
featured with new technology for higher effi-
ciency. The blades are not reversible.
1. Position the blade assembly on the motor
such that the mounting screw aligns with the
threaded hole. Turn the screw, spring washer
and flat washer into the hole but do not com-
pletely tighten. Make sure the second hole
in the blade assembly aligns with a hole in
Figure 8
the motor.
2. Install a second screw, spring washer and
flat washer in the blade assembly in the
same manner.
3. Install the remaining blade assemblies as per
1 & 2.
4. Tighten all screws.