Milwaukee 8911 Manual Del Operador página 6

Using the Vacuum Cleaner To Pick Up Wet Materials:
To reduce the risk of electric shock, DO NOT pick
up wet materials unless the vacuum cleaner is
properly set up to pick up wet materials.
A float valve shuts off suction when the tank is full. Be sure the float is
clean and moves freely in the float cage to ensure that the float valve
works (Figs. 3 & 4).
Fig. 3
Float
If the float is clean, moves freely and the suction
does not shut off when the tank is filled (you will
be able to see water in the exhaust port), send
the motorhead to the nearest MILWUAKEE
service facility for repair.
Cat. No. 8965 does not need a wet adapter for picking up wet materials.
The safety valve is already built in to the 8965 vaccum cleaner. Do not
remove the foam filter sleeve. It is designed to be used with both wet and
dry materials.
Installing Wet Adapter (Fig. 4)
1. Remove motorhead and set aside.
2. Set wet adapter into tank.
3. Replace motorhead and snap down tank latches.
Fig. 4
Page 6
WARNING!
Float cage
WARNING!
Float
cage
Float
Removing Liquid from the Vacuum Tank on Vacuum Cleaners
with Drain Valves
1. Center drain valve over floor drain.
2. Open drain valve.
For Cat. No. 8925, open drain valve by turning the drain valve handle
counter clockwise. To closedrain valve trun clockwise.
For Cat. No. 8924, 8926 and 8927, open drain valve by pulling up on the
handle. To close push down on handle.
3. Drain.
4. Rinse, dry tank and close drain valve.
Removing Liquid from the Vacuum Tank on Vacuum Cleaners
without Drain Valves
1. Remove motorhead and wet adapter and set aside.
2. Block wheels.
3. Carefully dump contents into floor drain.
4. Rinse and dry tank.
Do not store vacuum cleaner with liquid in tank. Run the vacuum for
about 5 minutes without picking up anything to dry the inside of the tank.
To reduce the risk of injury: wear saftey glasses
and a dust mask when using the vacuum cleaner
as a blower.
Using the Vacuum as a Blower
1. Attached hose exhaust port on the motorhead.
2. Attach the appropriate accessory to the hose.
3. Turn the vacuum on.
WARNING!