Installation And Assembly Site; Initial Set-Up; Operation With A Mains Adapter - VOSS sonic 360 Instrucciones De Uso

7

INSTALLATION AND ASSEMBLY SITE

The device is suitable for both indoor and outdoor use. When choosing the installation
site, observe the general safety instructions given in chapter 2 and the following points:
ऀ Make sure there is a properly installed electrical socket nearby if using the mains
adapter.
ऀ Do not position the device in depressions in the ground to protect it against
accumulations of water.
ऀ To achieve the best possible results, make sure that the side of the device is not
covered by furniture or curtains and that no carpet is fitted in the area of operation.
These would reflect or absorb the sound waves.
ऀ When using the device under a vehicle, make sure that the device is centred under
the vehicle with a clearance of at least 12 cm from the ground. If the VOSS.sonic 360
is operated using the mains adapter, make sure that the supply cable cannot be run
over by vehicle tyres.
ऀ Depending on the local conditions, the VOSS.sonic 360 can protect a space of up to
approx. 700 m². Make sure that no other property is exposed to sound without the
consent of the owner.
ऀ The feet (7) of the device are equipped with holes 4.5 mm in diameter for fixing the
VOSS.sonic 360 to the ceiling. Ceiling mounting is only permitted in roofed spaces
where it is ensured that no water (e.g. condensation) can drip onto the device.
8

INITIAL SET-UP

The VOSS.sonic 360 can either be operated using the included mains adapter or with
1.5-V D batteries (4 pieces).
WARNING
Use only one of the two energy sources mentioned.
Info
Continuous operation is only possible when using the mains adapter.
8.1

OPERATION WITH A MAINS ADAPTER

CAUTION
Trip hazard. Position the device and the cable of the mains adapter so that they
do not pose a tripping hazard to humans or animals. Do not position the device
or the mains adapter cable in walkways.
NOTICE
Use only properly installed sockets to supply the
device with power.
1. Open the lock on the mains connection (8) and insert
the plug of the mains adapter into the mains connection
(8) (Fig. 1).
2. Plug the other end of the mains adapter into a properly
installed power socket.
The device is ready for use.
18
INSTRUCTION MANUAL VOSS.SONIC 360
Fig. 1
45090 | 01 | 2021 | V3