Twin-Star International 23IW1254 Manual De Instrucciones Adjunto página 6

3. Locate Left Side Panel (E) and Right Side Panel (F),
insert one Wood Dowel (CC) into each of the
pre-drilled holes. Attach to the completed front panel
assembly and Hearth/Base use Bolts (AA) and
Washers (BB) through the pre-drilled holes in the
mounting blocks.
HAND TIGHTEN ONLY.
Hardware Used
AA
Bolt
BB
Washer
CC Wood Dowel
4. Locate Mantel/Top (G) and lay fi nished side up on
top of completed assembly. From the inside,
attach the Mantel using Bolts (AA) and Washers
(BB) through the pre-drilled holes in the Panels.
HAND TIGHTEN ONLY.
Using Phillips head screwdriver tighten all Bolts
alternating top and bottom, left and right.
Hardware Used
AA Bolt
BB
Washer
5. Remove the two mounting brackets attached to the
back of the Left and Right Front panels. Set aside
with the wood screws.
PLEASE READ ALL "ELECTRIC FIREPLACE
INSERT" INSTRUCTIONS PRIOR TO INSTALLING
ELECTRIC INSERT IN YOUR COMPLETED
FIREPLACE MANTEL. INSTALL THE INSERT IN
YOUR FIREPLACE CLOSE TO ITS FINAL
POSITION.
Lift insert carefully into the back of the unit and
center in the insert opening. Do not drag insert
across Hearth/Base (A) as it may scratch your unit.
Install the mounting brackets to hold insert fl ush
against the inside of the mantel front panel.
MOVE YOUR COMPLETED UNIT ONLY SHORT
DISTANCES. MOVE COMPLETED UNIT WITH
GREAT CARE. IT TAKES TWO PEOPLE TO MOVE
COMPLETED UNIT INTO ITS FINAL POSITION.
Fig. 3
x 10
x 10
x 4
CC
Fig. 4
x 8
x 8
Fig. 5
5
AA
BB
F
CC
G
BB
AA
Install
Insert
From
Back
Electric
Fireplace Insert
Completed
Unit
E
08/16/11