EHEIM 3611 Manual Del Usuario página 5

B Netzstecker ziehen. Durch Drehen des Einstellringes
a die gewünschte Temperatur einstellen. Netzstecker
einstecken. „Rotes Licht" f = Heizbetrieb.
Wenn die Einstellskala nach 1- 2 Tagen nicht mit der Was-
sertemperatur übereinstimmt, können Sie wie folgt vorge-
hen, um Ihren Heizer neu einzustellen:
•
Wassertemperatur mit genauem Thermometer messen
• Markierungspfeil (rot) b auf die gemessene Wasser-
temperatur drehen
gewünschte Beckentemperatur einstellen. • Netzstecker
einstecken.
Kenndaten (siehe Tabelle Seite 2)
Diese ngaben sind Richtwerte für geschlossene qua-
rien bei einer Wassertemperatur bis 26°C.
Nicht auf Glasschäden, unsachgemäße Behandlung und
Öffnen des Gerätes.
Im Störungsfall bitte an Ihren Fachhändler wenden –
Thermostatic aquarium heater
IMPORT NT S FETY INSTRUCTIONS
W RNING
precautions should be observed, including the follwing.
RE D ND FOLLOW LL
a)
S FETY INSTRUCTIONS
D NGER
b)
special care should be taken since water is
employed in the use of aquarium equipment. For
each of the following situations, do not attempt
repairs by yourself; return the appliance to an
authorized service facility for service or discard
the appliance.
1) If the appliance falls into the water,
reach for it! First unplug it and then retrieve it. If
electrical components of the appliance get wet,
unplug the appliance immediately. (Non immersi-
ble equipment only)
2) If the appliance shows any sign of abnormal
water leakage, immediately unplug it from the
power source. (Immersible equipment only).
3) Carefully examine the appliance after instal-
lation. It should not be plugged in if there is wa-
ter on parts not intended to be wet.
4) Do not operate any appliance if it has a dama-
ged cord or plug, or if it is malfunctioning or has
been dropped or damaged in any manner.
5) To avoid the possibility of the appliance plug
or receptacle getting wet, position aquarium
stand and tank to one side of a wallmounted
receptacle to prevent water from dripping onto
the receptacle or plug.
"drip-loop", shown in the figure "C", should be
arranged by the user for each cord connecting an
aquarium appliance to a receptacle. The "drip-
loop" is that part of the cord below the level of the
receptacle, or the connector if an extension cord
is used, to prevent water traveling along the cord
and coming in contact with the receptacle. If the
plug or socket does get wet,
cord. Disconnect the fuse or circuit breaker that sup-
plies power to the appliance. Then unplug and exa-
Temperatureinstellung
Nachjustierung
Mit der Einstellskala (blau) a die
•
Garantie: 3 Jahre
oder www.eheim.com
– To guard against injury, basic safety
– To avoid possible electric shock,
•
Netzstecker ziehen
DON'T
unplug the
DON'T