Marshalltown QLT PL11C Manual De Instrucciones página 5

outrIGGers
The outriggers on the crossarms extend for supporting a longer
drywall panel .
To extend an outrigger, pull out the lock pin with your right hand
until you can slide the outrigger out with your left hand . The lock
pin can engage to lock the outrigger at one of three positions: fully
retracted; extended 21 inches .; or extended 33 inches .
Important: Never load a drywall panel or operate the lift if the
lock pins are not engaged at one of the these three positions, or if
the outriggers are extended beyond the 33-in . position .
To avoid damaging them, always fully retract the outriggers before
transporting or storing the lift .
panel support hooks
Open the support hook on each crossarm to support the drywall
panel when it is being loaded, or when the cradle is tilted .
To avoid damaging them, always close the support hook before
transporting or storing the lift .
slIde bar loCk
The slide bar lock holds the winch assembly at its operating
(fully extended) position .
To fold the winch assembly against the frame (when disassembling the
unit for transport or storage), disengage the lock by turning it counter-
clockwise as you lift on the slide bar .
When you reassemble the unit for operation, extending the winch as-
sembly all the way and then pressing it back slightly toward the frame
automatically engages the lock .
never: tighten the nut on the slide bar lock, or you will be unable to
fold up the unit for transport and storage .
5