Wall Mounting - Panasonic KX-NT321 Guía De Referencia Rápida

NT321NE_GQ.book Page 15 Thursday, September 11, 2008 6:57 PM

Wall Mounting

1. Remove the stand if it is attached. For information on removing
the stand, refer to page 13.
2. Attach the wall mounting
adaptor as shown.
• Make sure the cables are not
pinched by the wall
mounting adaptor. When
running the cables from the
top of the unit, look through
the opening in the wall
mounting adaptor to confirm
that the cables are not being
• Slide the wall mounting
pinched.
adaptor in the direction
indicated until it locks into
place.
3. Drive the 2 screws into the
wall either 83 mm or 100
mm apart, and mount the
unit on the wall.
• You can find a wall mounting
• Make sure that the wall that
template on page 183.
the unit will be attached to is
strong enough to support the
• Make sure the cables are
unit (approx. 1.5 kg).
• When this unit is no longer in
securely fastened to the wall.
use, make sure to detach it
from the wall.
Wall Mounting
83 mm
100 mm
Washer
Drive the screw
to this point.
15