Publicidad
ORIGINAL ASSEMBLY AND OPERATING INSTRUCTIONS
GB
INSTRUCTION
Dear customer,
with your purchase of the D 1000 drive system from BERNAL
you have acquired a high-quality product. This device is inten-
ded for the actuation of double-leaf gates. We hope that this
product meets your expectations and thank you for the trust
you have placed in us.
If you have any questions regarding our products or the imple-
mentation options for the double-leaf gate actuator system,
please do not hesitate to contact our Service-Hotline:
STAMP/LOGO STOCKIST
Important safety note:
Make sure that work on your electrical cabling and the associa-
ted connection work is only carried out by a qualified specialist.
Such works pose a risk to health and life and therefore require
special expertise.
Areas of application / use:
» On privately used double-leaf gates
The BERNAL gate actuator systems are subject to a continuous
improvement and further development process. We therefore
reserve the right to implement changes due to technical pro-
gress and for the improvement of the products. Alterations and
deviations from the illustrations as well as printing errors are
reserved.
The performance of the actuator systems may be influenced by
various factors such as specific on-site construction and condi-
tions. No claims may arise based on the technical information
as this may differ in individual cases.
10
General safety regulations / safety notes for the installer
CAUTION!
To ensure the safety of persons, the instructions must be care-
fully read before proceeding with the installation of the product.
An incorrect installation or faulty operation of the product can
cause serious personal injury.
» The packaging material (plastic, styrofoam, cardboard) may
not be stored within the reach of children since it poses a po-
tential source of danger.
» The instructions must be stored carefully for future reference.
» This product has been exclusively developed and manufac-
tured for the application purposes described in this document.
Any other use that is not explicitly stated, could affect the inte-
grity of the product and/or represent a source of danger.
» BERNAL disclaims all liability for damages caused by impro-
per or incorrect use of the actuator system.
» The device may not be installed in explosion-prone environ-
ments. The presence of flammable gases or fumes represents
a severe safety risk.
» The mechanical parts must be conform with the requirements
of the standards EN 12604 and EN 12605.
» Countries that do not belong to the European Union, are re-
sponsible for ensuring an appropriate level of safety according
to national legal provisions beyond those defined by the above
mentioned standards.
» BERNAL will not assume any liability for a non-professional
manufacturing of the locking devices to be actuated, as well as
for deformations that may arise during the operation.
» The installation must be carried out in accordance with the
standards EN 12453 and EN 12445. The force setting of the au-
tomatic module must be adapted to the gate. The actuator has
a built-in safety device to prevent crushing injuries which con-
sists of a torque control. In any case it is necessary to adjust the
torque control to the gate appropriately. To minimize the risk of
injury as far as possible, the force setting of the gate controller
must be adapted to the gate as follows.
» After hitting an obstacle the actuator will reverse direction.
» Level 4 is the factory programmed the force setting.
Publicidad
