How To Change The Password; How To Change The Idle Timeout; How To Disable Wireless Admin Access; How To Change The Browser-Based Utility's Language - Cisco Linksys WAP300N Guia Del Usuario

Linksys WAP300N

How to change the password

You can change the WAP300N's password to limit access to the browser-based
utility
To change the password:
1. Log into the browser-based utility (see "How to open the browser-based
utility" on page 8)
2. Click the Administration tab, then click the Management page
3. Enter the new password in the Device Password field, then enter it again
in the Re-enter to confirm field
4. Click Save Settings

How to change the idle timeout

You are automatically logged out of the browser-based utility after a period of
inactivity You can set the length of the inactive period
To change the idle timeout:
1. Log into the browser-based utility (see "How to open the browser-based
utility" on page 8)
2. Click the Administration tab, then click the Management page
3. Enter the new timeout period in the Idle Timeout field You can enter a
range of 60 to 3,600 seconds
4. Click Save Settings to apply your changes

How to disable wireless admin access

For additional security, you can disable the ability to wirelessly log into the
browser-based utility With wireless access disabled, to run the browser-based
utility you must use a wired connection
To disable wireless admin access:
1. Log into the browser-based utility (see "How to open the browser-based
utility" on page 8)
2. Click the Administration tab, then click the Management page
3. For Access via Wireless, select Disabled, then click Save Settings
How to change the browser-based
utility's language
To change the browser-based utility's language:
Setup > Basic Setup
1. Log into the browser-based utility (see "How to open the browser-based
utility" on page 8) The Basic Setup page opens
2. For Language, select the language, then click Save Settings
Setting Up: Advanced
21