Water Pump Installation; Water Pump Safety Guidelines; Saw Operation - Brutus 61024 Manual De Operación

the wrenches upward to loosen (See Diagram 5) or move downward to tighten
(See Diagram 6) in order to open and close the blade shaft nut & outer flange.
Then, attach and secure the blade onto the blade shaft, keeping the inner flange
in place. Place the blade between the two water tubes in the back of
the bladeguard.
Step 3: Replace the blade guard to its original position and tighten knob.
Step 4: To remove or change the blade, just reverse the Installation steps.
CAUTION!
E. Water Pump Installation
Step 1: Make sure the water pump is not cracked or damage in any way.
Step 2: Attach the end of the tube to the pump nipple and L -shaped water flow at the
back of blade guard.
Step 3: Place the Pump at the location in the water tray that has been designed to secure
the pump during use. (See the Diagram 7).
Step 4: Pour the water into the water tray and make sure the water level is higher than
the pump intake nozzle.
Step 5: Keep the power cord end out of water and plug the power cord into the 3-prong
receptacle on the side of the cutting head assembly. The pump is activated by
the ON/OFF switch of the tile saw.
Step 6: Make sure that the water valve connecting the pump to the tubing is in the full
open position.
The following is the water pump safety guidelines.
1. Make sure the pump is connected to grounding-type receptacle to prevent the
electric shock.
2. Make sure the pump and tube is settled steadily to reduce any chance of pump damage.
3. Do not handle the pump by the power cord, with wet hand, or when standing on a
wet surface.
4. Never use the pump for anything other than water, especially gasoline, kerosene,
or other combustible or corrosive liquids.
5. Do not attempt to check the pump before disconnecting the power source if the
pump fails to operate.
6. Never operate the pump without water. The pump needs water to cool its own motor.
A dry pump may cause damage or danger.
F. Installing Rear Water Collection Tray
1. Insert and attach the Back Collecting Tray to the Tank at the corresponding joints.
(See Diagram 8)
G. Installing Extension Table & Side Extension Table
1. Installing Front Extension Table (See Diagram 9):
a. Place the Extension Table in the back of the Main Working Table.
b. Secure the Extension Table with the supplied round cap HEX bolts.
2. Installing Side Extension Table (See Diagram 9):
a. Insert the Side Extension Table tubes into the side tunnels at front and back of the
Main Working Table.
b. Insert the Pins at the ends of Side Extension Table tubes to hold them in place.

SAW OPERATION

CAUTION!
1. Do not adjust the saw without first turning off the motor. Failure to do so may result
in serious injury to the operator.
2. Always keep the saw clear. Never put things on rail while cutting.
Make sure that the directional arrow on the blade
points in the same direction as the arrow marked on
the blade guard fixing plate.
- 9 -
Diagram 7
Diagram 8
Diagram 9
Diagram 10
Diagram 11