Kongskilde KG Serie Manual De Instrucciones página 2

GB
1. General Instruction
The heaters mentioned in this
maintenance leaflet must exclu-
sively be used outdoors or in
ventilated surroundings.
For every kW it is necessary to
have an outlet of 25 cm
distributed between the superior
and inferior part of the room,
with a minimum outlet of 250
2
cm .
Gas cylinders must be used and
kept in accordance with the
existing norms for such materi-
als.
Never direct the hot air flow
towards the cylinder.
Use only the supplied pressure
regulator.
Never use the heater without its
cover.
Do not exceed 100 W/m
ering the empty volume. Anyway
the volume of the room must be
3
greater than 100 m .
Do not reduce the inlet or outlet
sections of the heater.
2
If the heater has to work for a
long period at its maximum
capacity, it is possible that ice
will form on the cylinder. This is
due to excessive evaporation.
Neither for this reason, nor for
any other, must the flow of hot
air be directed towards the cylin-
der. In order to avoid this effect,
or at least to reduce it, use a
large cylinder or two cylinders
linked together (Fig.1).
2 Do not use the heater in cellars,
, equally
basements or in any room be-
low the ground level.
In case of malfunction, please
contact the technical assistance
service.
The heater must be isolated
from the gas bottle by means of
a valve.
The gas bottle must always be
replaced following safety rules
and without any live flame.
The gas hose must not be twist-
ed or bent.
3 consid-
The heater must be placed
where there is no risk of fire, the
hot air outlet must be at least 3
m from any flamable wall or
ceiling and must never be di-
rected towards the gas bottle.
Only use original gas hose and
spare parts.
Heaters described in this leaflet
are not intended for domestic
use.
If a gas leak occurs, please fol-
low the necessary safety rules.
2. Installation
Connect the heater to an electric
socket (220/240 V ~ 50 Hz).
Make sure that the machine is
properly earthed.
Connect the gas supply hose to
the pressure regulator and con-
nect the regulator to a GPL cylin-
der.
Open the tap of the cylinder and
control the supply hose and
fittings for eventual gas leaks.
For this operation it is recom-
mended to use a soap foam.
NEVER USE NAKED FLAME.
For automatic appliances, con-
nect the room thermostat to the
socket on the appliance and
adjust it to the required tempera-
ture.
Fig. 1