Installation Of The Cam And Milling Machine Software - Amann Girrbach ceramill mikro ic Modo De Empleo

5.4 Installation of the CAM and milling
machine software
▷ Insert the CAM software CD-ROM into the drive
of the PC.
The software to be installed is on the CD.
▷ Execute the ".exe" file and follow the directions
on the monitor.
Connecting the interfaces
1 2 3
8 7
4
5
6
Fig. 6 Interfaces on the rear side of the milling
machine
1 Slot for SD memory card
2 Ethernet interface
3 USB data port
4 Compressed-air connection, milling spindle
5 Connection, C/L supply line
6 Connection, C/L drain
7 Power supply connection
8 Main switch
▷ Make sure that the main switch [8] of the milling
machine is in the 0 position.
▷ Check if the SD memory card is properly seated
in the slot [1] on the rear side of the milling
machine.
I N S T A L L A T I O N
▷ Connect the mains cable to power supply con-
nection [7] of the milling machine as well as to a
mains socket outlet.
Connecting to the PC
▷ Connect a USB cable to the USB interface ([3] in
fig. 6) of the milling machine and to a free USB
port of the PC.
The maximum permitted length of the USB
cable is 5 m.
▷ Insert the CAM Dongle in a free USB port on the
rear side of the PC.
Fig. 7 CAM Dongle
E N
37