Rear Panel Connections; Front Panel Connections - Numark DJ iO Inicio Rápido

REAR PANEL CONNECTIONS

1. USB PORT – Please use the supplied USB2.0 cable to
connect this port to an available USB2.0 port on your
computer. When plugged into your computer, the unit
will draw power from the USB connection.
Please note: The DJ IO requires a USB2.0 connection in
order to function fully and properly.
connection, only OUTPUT 1 will work. To take advantage of
both outputs, please make sure that you are connecting to a
USB2.0 compatible port on your computer.
2. DC IN – If your computer does not supply enough power through the USB bus, you may wish to power
the unit externally by connecting an optional 6V/1A adapter to this input and plugging the adapter into a
power supply.
3. OUTPUT 1 – This stereo RCA connection will output the Master Mix from your computer. Please use a
stereo RCA cable to connect this output to a powered speaker or amplifier system.
4. OUTPUT 2 – This stereo RCA connection will output the Cue Mix from your computer for monitoring
purposes. Please note that the Cue Mix is also output through the Headphone Output on the front
panel.

FRONT PANEL CONNECTIONS

1. POWER INDICATOR – This LED will light up to let you
know that the DJ IO is on.
2. MIC THROUGH INPUT – This is a ¼" microphone input.
The signal from this input will be sent directly to the
Output 1 (Master Mix) RCA output.
3. MIC VOL – This knob controls the microphone level being sent to Output 1 (Master Mix).
4. HEADPHONES – This stereo ¼" output will output the signal being routed to Output 2 (Cue Mix). To
take full advantage of cueing and monitoring through this output, please make sure that you have routed
the Cue Mix in your software to Output 2 of the DJ IO.
If using a USB1.1
6