LUCCI AIRFUSION QUEST II 48” Manual De Instrucciones De Instalación página 7

Airfusion QUEST II Installation Instructions
LIGHT KIT INSTALLATION
Fig. 6
1. Remove the decorative cover from the shaft.
2. Pull the L and N wire out from the shaft.
3. Insert wires through the light connector (1).
4. Tighten the light connector into the shaft firmly with a spanner.
5. Secure the light base (2) to copper connector (1) by tightening the screw nut (3).
6. Take off the wire protective cover (5) from terminal block (4) by loosening the screw nut (6).
7. Connect the L and N wire from fan to the terminal block (4) on the light base according to the label.
8. Re-install the wire protective cover.
9. Install the globes (not included).
10. Lift and attach the glass (7) to the lamp base and secure it by using three spring clips (8).
7 | P a g e
Fig. 7