PACKING LIST
String Trimmer
Connection Tube
Safety Guard
Owner's Manual
Hardware Bag
Cable Sleeve
UNPACKING
This product requires some assembly.
Carefully remove the product and accessories from the box. Make
sure that all items listed in the packing list are included.
Inspect the product carefully to make sure no breakage or damage
occurred during shipping.
Do not discard the packing material until you have carefully
inspected and satisfactorily operated the product.
If any parts are damaged or missing, please call customer service
at 1-800-313-5111 for assistance.
WARNING: Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental starting and
possible serious personal injury.
WARNING: If any parts are damaged or missing do not operate this
product until the parts are replaced. Failure to heed this warning
could result in serious personal injury.
WARNING: Do not operate the trimmer without the guard attached.
ASSEMBLING THE CONNECTION TUBE
Attach the bottom and top sections of string trimmer to the
connection tube. (Fig 1)
Insert the bolt into the upper handle and connection tube and
secure with nut. (Fig 2)
ASSEMBLY
Insert the bolt into the trimmer head and connection tube and
secure with nut.(Fig 3)
Ensure the electrical cable is inserted into the groove of the
connection tube and install the cable sleeve. (Fig 4)
ATTACHING SAFETY GUARD (See Fig 5)
Assemble the guard as shown. Insert the tabs of the guard into the
slots located at the rear of the motor housing.With a Phillips screw
driver, secure the two (2) screws into the guard and motor housing.
Remove protective tape from blade on the guard.
Fig 1
Fig 2
4
Model ST00090
Fig 3
Fig 4
Fig 5