Maintenance And Storage - Antec EN 361 Instrucción De Utilización

a PPE yourself. Only the manufacturer
or a repair centre is qualified to carry
out these repairs.
Check the serviceable condition of the
harness : ( cf. 7 ) :

No incipient breaks in the
webbing,

No deformation of the D-links,

Correct operation of the buckle
systems,

Integrity of the seams,

Good condition of the metal
components.
SPacE cLEaRaNcE
If there is a risk of falling, or if ancho-
rage cannot be provided below the
attaching points of the harness, it is
essential to use a lanyard fitted with
an energy absorber Before using an
energy absorber incorporated into a
lanyard, check for a minimum space
clearance below the user's feet as ne-
cessary, to prevent any collision with
the structure or the ground. With a
weight of 100 kg and a fall factor of
two ( worst case scenario ), the air
clearance D is the stopping distance
H ( 2L+1.75m ) plus an additional dis-
tance of 1 m. ( cf. 8 ).
PERIODIc EXamINatION
These instructions must be kept with
the product. Fill in the identification
sheet and enter the markings informa-
tion. This periodic examination, which
verifies the effectiveness and strength
of the equipment is indispensable
in guaranteeing the user's safety. A
qualified person must examine this
equipment at least once each year,
in strict compliance with the instruc-
tions of the manufacturer and the
examination must be recorded on
the attached sheet. The frequency of
the examination must be increased in
accordance with regulations in case
of heavy usage or in difficult environ-
mental conditions. The legibility of the
product markings must be checked.
LIFESPaN
The maximal life of PPE that is predo-
minantly textile is evaluated as being
10 years after the date of manufac-
ture. However, the following factors
may reduce the performance of the
product and its lifespan : incorrect
8
storage, improper use, fall arrest,
deformation, contact with chemical
products (alkali and acid), exposure to
sources of heat > 60°C ( cf. 9 ).
aNcHORaGE POINt
If possible, use with structural anchors
( compliant with EN 795 ), that is, ele-
ments securely attached to a structure
( wall, post, etc.). In all cases, check
that the anchorage point :

Offers minimum resistance of 10
kN,

Is situated above the operator, (
cf. 10 ).

Is vertically in line with the
working surface: (maximum angle
± 30°),

Is totally suited to the equipment
attaching device

Has no sharp edges

maINtENaNcE aND StORaGE

Good maintenance and storage of
your PPE will prolong the working-life
of your product, while also ensuring
your safety ( cf. 9 ). Be sure to comply
with these recommendations:

The harness should be cleaned
with water and a mild soap. Never
use acid, solvents or any solvent-
based product,

Leave to dry in a well-ventilated
area, away from sources of heat.
Store the harness away from humi-
dity and ultraviolet light,

Avoid any atmosphere that is
corrosive or excessively hot or
refrigerated.
caRaBINER
Connector is compliant with standard
EN 362

When the carabiner is used for
attachment to an anchorage point,
check for compliance with the
recommendations of the "ANCHO-
RAGE POINT" paragraph ;
It is also possible to use a runner (EN
795) or an anchoring clamp (EN 362)
to attach oneself to an anchorage
point.
WHEN cONNEctING tHE
caRaBINER, maKE SuRE tHat
tHE LOcKING SYStEm IS IN
PLacE .