Safety Information - Utilitech Pro SE1048-BP2-02LF0-U Manual Del Usario

SAFETY INFORMATION

WARNING : To reduce the risk of FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS:
1. Do NOT touch LEDs.
2. Do NOT remove the protective clear LED lens.
3. Do NOT look directly at lighted LEDs for any length of time.
5. Electrical requirements: 120 V AC, 60 Hz., 0.31A. Minimum 90° supply conductors.
6. Do not leave bare wires exposed outside the wall canopy enclosure.
7. Suitable for installation onto round surface mount electrical boxes or recessed electrical boxes rated
for wet locations. Fixture can be wall or eave mounted. NOT suitable for ground mount installations.
8. Do NOT allow the sensor head to touch the LED head housing. Maintain at least 1 in. spacing
between the LED heads and the sensor head.
9. For proper operation and protection against water damage, the motion sensor head controls MUST
be facing downward.
10. Do NOT mount below 5 ft.
pools or bodies of water, or trees/bushes that move in the wind. All of these may trigger the motion
sensor security light and may be disruptive to the intended operation of the light. Do NOT install near
other sources of light, as this can fool the Dusk-to-Dawn sensor into thinking it is daylight.
PREPARATION
Before beginning installation of product, make sure all parts are present. Compare parts with package
contents list and hardware contents list. If any part is missing or damaged, do not attempt to install the
product.
Estimated Assembly Time: 45 minutes. Tools Required for Assembly (not included): Phillips screwdriver
and silicone adhesive caulking.
INSTALLATION INSTRUCTIONS FOR ROUND SURFACE MOUNT ELECTRICAL BOXES
present, keep track of which wires were connected together.
1. Pull the supply wires out of the electrical box. Using
box, secure the mounting strap (CC) to the electrical
box, making sure that the side marked "FRONT" is
facing out.
Hardware Used
AA
Machine Screws
BB
CC
Mounting Strap
2. Remove the protective paper barrier from the adhesive
face of the foam gasket (GG). Trace the supply wires through
the openings in the gasket and adhere the gasket to the
mounting strap and outer edge of the round surface mount
electrical box.
Hardware Used
GG
Foam Gasket
x 2
GND
x 1
FRONT
x 1
3
1
2
Lowes.com
AA
CC
GG