Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
CHECKING REMOTE-BOARD PAIRING
The Connection and Mode Indicator will turn solid
blue when the board is paired. If the indicator is not
lit, check that the board is powered on. If the light is
still not lit, press the Multi-Button on the remote 5
times (5x), followed by pressing the Power Button on
tap 5x
CHANGING RIDE MODE
This board ships in Beginner Mode. Before following
the instructions below to switch modes, make sure
you have mastered the use of the remote and board.
Beginner:
limited acceleration, top
speed of up to 11 mph, no hills.
Eco:
moderate acceleration, top speed
of up to 16 mph, small hills.
Expert:
high acceleration, top speed of up
to 20 mph, up to 20% grade hills.
Pro:
extreme acceleration, top speed of up
to 22 mph, up to 25% grade hills.
Hyper (Stealth Only):
max acceleration, top
speed of up to 24 mph, up to 25% grade hills.
Warning: The Throttle Wheel is much more
sensitive in Pro Mode and Hyper Mode.
To avoid getting thrown off the back of the board,
follow these tips:
• Keep a wide stance on the board.
• Keep a low center of gravity.
• Move the Throttle Wheel in small increments.
• Lean forward when accelerating.
• Lean backwards when braking.
10 Boosted Stealth / Boosted Plus Manual
the board 5 times (5x) rapidly to pair your board.
Your board and remote have already been paired
prior to shipping, so you typically only need to
do this when pairing to a new board or remote.
tap 5x
To Cycle Through Modes
Come to a full stop. Tap the Multi-Button 3
times (3x) rapidly to change modes. Count the
LED flashes to identify which mode you are
in. Count the AUDIO beeps to identify which
mode you are in (1 beep, 2 beeps, 3 beeps).
1 beep / 1 flash
2 beeps / 2 flashes
3 beeps / 3 flashes
tap 3x
4 beeps / 4 flashes
5 beeps / 5 flashes
(Stealth Only)
REMOVING BATTERY PACK
(FOR MAINTENANCE ONLY)
• First ensure that the board is turned off.
• Place the board upside down on a flat surface.
• Using a 4mm hex wrench, remove the six bolts
fastening the battery pack to the deck.
• Lift the battery pack to reveal the connector
between the deck and the battery pack.
• Using a pair of connector tools, carefully twist
and pull the battery connector apart.
MORE INFORMATION ONLINE
This manual is intended for someone with some
skateboarding experience to get started. For more
advanced riding techniques, maintenance tips, or
more detailed tutorials on learning how to ride,
please visit boostedboards.com/support
or youtube.com/boostedboards.
REPLACING BATTERY PACK
• To insert a new battery pack, align the grooves on
both ends of the connector (board & battery pack).
• Insert, push together, and twist the two
ends of the connector together.
• Use the battery connector tools to ensure a secure fit.
• Ensure the connector lays flat within the groove of
the board side by side with the accessory wire.
• Replace and tighten the bolts with the hex wrench.
Boosted Stealth / Boosted Plus Manual 11
EN
Publicidad
Tabla de contenido
