Operating Instructions - Kobalt KML 124B-03 Manual De Instrucciones

OPERATING INSTRUCTIONS

1. To Attach Battery Pack
a. Align the raised portion on the battery pack
with the grooves on the bottom of the tool,
then slide the battery pack onto the tool, as
shown.
b. Make sure that the battery-release buttons
on the battery pack snap into place and the
battery pack is secured to the tool before
beginning operation.
NOTICE: When placing the battery pack on the
tool, be sure that the raised rib on the battery pack
aligns with the groove on the tool and the latches
snap into place properly. Improper assembly of the
battery pack can cause damage to internal components.
To Detach Battery Pack
a. Press the battery-release buttons to release the battery pack.
b. Pull forward on the battery pack to remove it from the tool.
WARNING
• Battery tools are always in operating condition. Therefore, always turn off the light when the
light is not in use or when carrying the tool at your side.
2. ON/OFF Switch
a. To turn the work light ON, press the ON/OFF
switch (D). The work light will be turned on at
maximum brightness.
b. To reduce the brightness, press the ON/OFF
switch again.
c. To turn it OFF, press the ON/OFF switch a third
time.
WARNING
• Do not continue to press the ON/OFF switch
after the work light has automatically switched
off. The battery can be damaged.
• When the battery charge is low, the work light
will cycle from maximum brightness to lower brightness, back to maximum brightness, and
then turn off. Charge the battery to avoid battery damage.
1
Battery-Release
Buttons
2
D
7