Setting Your Digital Surround Sound Receiver; Receiving A Digital Audio Signal; Setting Your Analog Surround Sound Receiver - Bose Acoustimass 16 Serie Guía De Usario

U
SING YOUR SYSTEM

Setting your digital surround sound receiver

Figure 10
Digital signal receiver
connections

Setting your analog surround sound receiver

12
®
Speakers in your Bose Acoustimass
fully compatible with the audio output of digital surround receivers. The system's integrated
signal processing supports full low-frequency reproduction from all channels.
To gain complete advantage of these system capabilities, you may want to adjust some!
settings on your receiver. To make changes, use the digital display menu on the receiver and
refer to the list of recommended settings, below.
Speaker
• Left and right
• Center
• Left and right surround
• Center surround*
• LFE/Subwoofer
* With an Acoustimass 16 Series II system or upgraded Acoustimass 15 Series IlI system only.
Note: If your receiver provides it, the LFE or Subwoofer option setting should be ON and the
crossover value at the lowest number possible, which is typically 80 Hz.

Receiving a digital audio signal

For the digital audio signal from your DVD player to reach your surround receiver, you need a
digital audio connection between the DVD player and receiver (Figure 10).
1. Use either the Optical or Coaxial input (not both) on the receiver to connect to the digital
output from the DVD.
2. Be sure to select the digital output in the setup menu of your DVD player.
For additional setup and operating information, please refer to the owner's guide that came
with your surround receiver.
Use one or the other,
NOT both
For analog (non-digital) surround sound applications, we recommend that you set the !
surround sound center mode of your receiver to Wide. For instructions on how to change this
setting, refer to the owner's guide provided with your surround receiver.
Français
®
16 Series II or Acoustimass 15 Series III system are
Receiver setting
LARGE
LARGE
LARGE
LARGE
ON
Español English