Fantech GDC Serie Manual De Instalación, Operación Y Mantenimiento página 3

Assembly
Wheel / Handle Assembly
1 Position unit on back. Remove 4
shipping screws and discard.
5 Install one short tube. Install
one handle screw and tighten.
!
9 Install one long tube, plastic
bushing faces inward. Insert one
handle screw.
Do not tighten.
13 Position unit upright.
Wait 30 minutes before starting to
allow compressor to drain back.
2 Slide wheen axle into wheels
brackets. Offset to one side.
6 Install two wheels on wheel axle.
10 Insert bent tube into long tube.
Rotate long tube to align with
cabinet hole and insert one
handle screw.
Do not tighten.
3 Install one short tube on wheel
axle.
7
7 Install washer and lynch pin to
each wheel axle end.
Personal injury hazard.
Do not place fingers in ring areal.
Ring is spring loaded and closes
with force.
11 Insert hand axle. Insert second
long tube.
4 Install bent handle on short
tube. Install one handle screw
and tighten.
Lower Door, Second
Handle Assembly
8 Position unit with air filter up.
12 Insert two handle screws.
Tighten all handle screws.
3