Descargar Imprimir esta página

Gc ™ 200 Ip Marine Camera Installation Instructions; Mounting Considerations; Connection Considerations - Garmin GC 200 Instrucciones De Instalación

Ocultar thumbs Ver también para GC 200:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 10
GC
200 IP Marine Camera
Installation Instructions

Mounting Considerations

See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
You can mount the camera upside-down or sideways. You can
reverse the camera image to use in rearview mode. See your
chartplotter owner's manual for instructions.
NOTE: You must update your chartplotter software to setup and
view the camera feed on your chartplotter.
• You must mount the camera in a location where it is not
submerged, does not present a hazard in doorways or
walkways, and cannot be damaged by docks, pilings, or other
pieces of equipment.
• You should mount the camera in a location strong enough to
support the weight of the device and where you can remove
the camera.
• You should mount the camera so the LED is visible and the
cables can be connected easily.
• To avoid interference with a magnetic compass, do not
mount the camera closer to a compass than the compass-
safe distance value listed in the product specifications.
• You should test the camera in the selected location before
you permanently mount the camera.
• You can use the Garmin
installation easier. The Power Module uses a single camera
cable instead of separate power and ethernet cables. This is
especially beneficial when the camera is located far away
from other electronics, such as near the bow or on a mast.
Tools Needed
1
• Drill and 2 mm (
/
in.) drill bit
16
• Pozidriv
screwdriver
®
Mounting the Camera
1
Secure the template to the mounting location.
1
2
Using a 2 mm (
/
in.) drill bit, drill the pilot holes.
16
3
Using the included hex wrench, loosen the screw in the side
of the camera base.
4
Remove the base from the camera body.
5
Feed the camera cables through the camera base, or through
one of the cable channels.
6
Align the camera base with the pilot holes, and secure the
camera base
with the washers
2
WARNING
®
Power Module to help make the
and screws
7
Attach the camera
the camera base.
8
Connect the camera cables.
9
Align the slots on the camera base
and turn the collar

Connection Considerations

Connection Diagram with Direct Power
GC
200 marine IP camera
Garmin Marine Network cable small connector (included)
Garmin Marine Network Adapter Cable small to large (included)
9 to 18 Vdc power source (not included)
To avoid permanently damaging the camera, do not connect the
camera directly to a 24 Vdc system. You must use a Garmin Power
Module when connecting to a 24 Vdc system.
1 A fast-acting fuse (required, not included)
You must connect the power wire through a 1 A fast-acting fuse
(not included). Without a fuse, the device can malfunction.
Garmin chartplotter (not included)
Connection Diagram with a Garmin Power Module
.
GC 200 marine IP camera
Garmin Marine Network cable small connector
Power module (010-12527-00, not included)
In-line switch (not included)
9 to 32 Vdc power source (not included)
Chartplotter (not included)
to the base, and tighten the screw in
with the collar lugs
until it locks.
NOTICE
NOTICE
Installation Instructions
,

Publicidad

loading