Troubleshooting - GMC GID12 Manual De Usuario

Atornillador de impacto 12 v
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 42

Troubleshooting

Problem
Red and green LEDs do not illuminate to indicate the battery
is correctly charging
Battery pack has low capacity
Impact Driver cannot be switched on (Trigger Switch (6)
does not move)
Impact Driver does not start when Trigger Switch is
depressed
Possible cause
Battery not correctly connected to charger
Clean battery socket of charger and battery contacts and
fully slide on to charger so it clicks in a locked position
Battery not being fully charged
Battery pack has been charged over 100 times and capacity
has started to reduce
The Forward/Reverse Switch may be in the middle ('locked')
position
Battery completely discharged
Defective battery
Tool defective
9
Solution
Clean battery socket of charger and battery contacts and
fully slide on to charger so it clicks in a locked position
Recheck mains connection
Do not remove battery until a full charge is indicated
This is normal for battery packs. Contact your GMC dealer to
purchase a replacement battery pack
Slide the Forward/Reverse Switch either to the left or right
Recharge battery or replace with a fully charged battery
Replace battery
Contact your GMC dealer or authorised service centre
GB

Publicidad

Tabla de contenido
loading

Tabla de contenido