NUTOOL BTL212 Manual Del Usuario página 26

Sierra de inglete con laser
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 47
GB
BTL305:
COMPONENTS AND CONTROLS (PIC.1)
1
Retractable blade guard
2
Handle
3
Static blade guard
4
Fence
5
Dust bag
6
Mitre degree scale
7
Mounting holes
8
On/Off trigger
9
Carry handle
10
Brush cover and motor housing
11
Blade guard release lever
BTL212 ( * = BTL250):
COMPONENTS AND CONTROLS (PIC.1)
1 *
Handle c/w motor and On/Off switch
2 *
Blade casing
3 *
Blade guard
4 *
Rotating table
5 *
Table lock knob
6 *
Dust bag collector
7 *
0 – 45°lock knob
CAUTION:
When boxed or during storage and transportation the saw head
is locked in the down position.
WARNING!
Before carrying out any maintenance or adjustments the
machine must be disconnected from the mains power supply.
INSTALLING THE MITRE SAW (PIC.2)
This machine has four 12mm mounting holes in its base (Pic.2)
(2.1). These can be used to perma nently secure the saw to a
workbench with suitable screws or bolts. Alternatively, if the
machine needs to be moved frequently it can be secured to a
base of 19mm plywood to provide a more stable base.
ASSEMBLY (PICS.3&4)
With exception of the dust collection bag and the table locking
knob, this machine comes fully assembled.
FITTING THE TABLE LOCKING KNOB (PIC.3)
To fit the table locking knob locate the threaded hole in the front
of the table and screw in the table locking knob (Pic.3) (3.1) .
12
TCT blade
13
Bevel locking lever
14
Bevel degree scale
15
Table locking knob
16
Mitre latch
17
Spindle lock
18
Rear lower guard
19
Dust outlet
20
Lock down pin
21
Scale pointer
22
Power lead
8 *
Base
9 *
Bench mounting holes
10 *
Blade guard lock
11 *
Degree scale
12 *
Pointer
13 *
Fence
14 *
Laser unit
15
Laser battery compartment
FITTING THE DUST COLLECTION BAG (PIC.4)
Fit the dust bag over the extraction outlet situated at the rear
of the machine (Pic.4) (4.1). The outlet has a hinged flap which
deflects the saw dust downwards when the dust bag is not used.
The flap is shown in the up position to allow the dust bag to
be attached (Pic.4) (4.2). The dust collection bag should be
emptied frequently as a full bag reduces its effectiveness to
collect dust particles.
Caution: Dust particles may cause respiratory problems
especially those from MDF board. For protection it is
recommended that an approved dust mask is worn.
Caution. When boxed or during storage and transportation the
saw head is locked in the down position. To release the head
ready for operation apply downward pressure to the handle
and pull out the lock pin (Pic.5) (5.1) and allow the head to rise
gently to its upper position.
ADJUSTMENTS REQUIRED BEFORE USING THE
MACHINE (PICS.6 TO 18)
The following adjustments must be made before operating the
26

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Btl250Btl305

Tabla de contenido