Reversing The Door Swing; Tools You Will Need - GE PFMS1NFX Manual De Uso

REVERSING THE DOOR SWING

IMPORTANT NOTES
When reversing the door swing:
NOTE: Door swing is not reversible on stainless
steel models.
• Read the instructions all the way through
before starting.
• Parts are included in the door hinge kit.
• Handle parts carefully to avoid scratching
paint.
• Set screws down by their related parts to
avoid using them in the wrong places.
• Provide a non-scratching work surface for
the doors.
IMPORTANT: Once you begin, do not move the
cabinet until door-swing reversal is completed.
These instructions are for changing the hinges
from the right side to the left side—if you ever
want to change the hinges back to the right side,
follow these same instructions and reverse all
references to left and right.
• Once door swing is finalized, ensure
the logo badge is properly aligned and
permanently secured to the door by removing
the adhesive cover on the back side.
NOTE: A replacement logo badge is included
in the hinge kit.
Unplug the refrigerator from its electrical outlet.
Empty all door shelves, including the dairy
compartment.

TOOLS YOU WILL NEED

Adjustable Wrench
Masking Tape
Phillips Screwdriver
Installation Instructions
5/16ʺ Socket
Ratchet/Driver
Thin-blade Screwdriver
Torx T-20 Driver
(Single Door Refrigerator Models only)
REMOVE THE
1
REFRIGERATOR DOOR
A Tape the door shut with masking tape.
B
Remove the hinge cover on top of the
refrigerator door by removing the Phillips
head screws and pulling it up.
C
Using a 5/16ʺ socket ratchet/driver,
remove the bolts securing the top hinge to
the cabinet. Then lift the hinge straight up
to free the hinge pin from the socket in
the top of the door.
D
Remove the tape and tilt the door away
from the cabinet. Lift the door off the
center hinge pin. Ensure that the plastic
hinge pin thimble remains on the hinge pin
or inside door hinge pin hole located in the
bottom of the door.
E
Set the door on a non-scratching surface
with the inside up.
71
Hinge Cover
Top Hinge