HOW TO OPERATE
STEP 1
After preparing the ingredients, plug the power cord into a wall outlet.
Note |
• Do not touch the power cord with wet hands.
short-circuit, or fi re.
• Check the safety of the wall outlet.
STEP 2
Press the FORWARD button to operate.
Note |
• Forward: Pulls down and slowly masticates the ingredients.
• Reverse: Pushes the ingredients back up to dislodge them.
If the ingredients become jammed in the UltraSqueezer™ and the hopper does not open,
press the OFF button. Then press and hold the REVERSE button until the ingredients become
dislodged. Repeat REVERSE - OFF - FORWARD as often as needed to achieve the desired result.
If the maXtractor™ stops during operation:
Switch the button to OFF position then press and
hold the REVERSE button until the ingredients
become dislodged.
Repeat REVERSE - OFF - FORWARD as needed.
1
▶
OFF
Note |
• REVERSE: Pushes the ingredients back up to dislodge them.
The REVERSE button only works while holding down the switch.
• Switch OFF ensuring that the maXtractor™ comes to a complete stop. Then press
REVERSE.
Hold the REVERSE button for 2-3 seconds and release. Repeat as needed.
Let the maXtractor™ stop completely before using the REVERSE button to prevent
malfunction.
• If the maXtractor™ does not work after these steps, disassemble and clean the
parts before operating the maXtractor™ again.
10
It may cause electrical shock,
FORWARD : Pulls down the food
OFF : Stops the operation
REVERSE : Pushes the food back up
2
3
4
▶
▶
REVERSE
OFF
FORWARD
STEP 3
Insert the prepared ingredients one piece at a time.
Note |
• Fibrous leafy vegetables (celery, kale, etc.):
» Separate each stem. Cut the outer stems that are thick and tough to 4 inches long or
less.
» Bundle up the leafy vegetables as inserting into the maXtractor™. Alternate between
leafy parts and stems.
• Before extracting, remove hard seeds or pits in ingredients.
• When juicing frozen fruits with small seeds, ensure that even the seeds are completely
thawed.
• Insert the ingredients one piece at a time.
●
Tip |
• Align the dots
and slide the pusher in.
• After inserting ingredients, use the pusher when it is necessary. Too much use of the
pusher may aff ect the juice quality.
» Intermittently use the pusher for soft ingredients like tomatoes and apples. Constant
use of pusher for soft ingredients may aff ect the juice quality.
STEP 4
Use the smart cap to make mixed juices,
stop juice from dripping, or rinse between
diff erent juices.
Tip |
• Juicing with the smart cap closed creates various mixed juice creations when
diff erent fruits and vegetables, milk, banana, beans etc. are selected.
• After juicing, close the smart cap to stop the juice from dripping, especially when
disassembling the juicing bowl off the base.
• When making diff erent juices quickly rinse away any leftover fl avors by running a
glass of water in the maXtractor™ with the smart cap closed.
Note |
• Leave the smart cap open when juicing ingredients that create excessive foam
during extraction, (e.g. apples, celery).
• Pay close attention when operating with the smart cap closed. Juice may overfl ow
if the juice collected in the juicing bowl exceeds its capacity marked on the bowl.
STEP 5
After juice and pulp are completely extracted, switch the unit OFF.
Note |
• If the remaining ingredients in the juicing bowl have not been extracted completely,
the hopper may not open easily.
additional 30 seconds to let the maXtractor™ extract the remaining pulp.
• When the hopper is stuck, press the REVERSE - OFF - FORWARD button in this order;
switching back and forth 2 or 3 times to dislodge the ingredients. Then place hands
on top of the hopper and fi rmly press down while simultaneously turning it counter
clockwise to open.
» Depending on the ingredients, pour water down the hopper to rinse out the interior
of the juicing bowl and then attempt to remove it.
After each extraction, run the maXtractor™ for an
Smart cap
11