Switching Off; Setting The Stroke Rate; Changing The Engraving Point - Parkside PGG 15 A1 Instrucciones De Utilización Y De Seguridad

Operation
Switching on:
Press the ON / OFF switch

Switching off:

Release the ON / OFF switch

Setting the stroke rate

The stroke switch
ing. A low setting is normally adequate for most engraving tasks.
Turn the switch for the number of strokes
increase the penetration depth.
Turn the switch for the number of strokes
decrease the penetration depth.
Note: Take care when increasing the penetration depth that you do
not turn the stroke switch
switch could screw off the device.

Changing the engraving point

performing any tasks on the device and pull the mains plug out of the
mains socket.
Replace the engraving point
and no longer provides the desired engraving performance. Turn
the engraving point holder
point is released.
5
62 GB/MT
.
1
is used to set the penetration depth of the engrav-
2
too far in the + direction. Otherwise the
2
RISK OF INJURY! Switch the device off before
5
6
.
1
in the + direction to
2
in the – direction to
2
as soon as it becomes too worn
anticlockwise until the engraving