Instructions For Use; Inserting/Replacing The Battery; Inserting/Changing The Saw Blades - Flex RS 29 18.0 Instrucciones De Funcionamiento Originales

Akku-Säbelsäge RS 28-18.0.book Seite 16 Freitag, 3. Juli 2015 2:41 14

Instructions for use

Before switching on the power tool
Unpack the power tool and accessories and
check that no parts are missing or damaged.
NOTE
The batteries are not fully charged on
delivery. Prior to initial operation, charge
the batteries fully. Refer to the charger
operating manual.

Inserting/replacing the battery

 Press the charged battery into the power
tool until it clicks into place.
 To remove, press the release button (1.)
and pull out the battery (2.).
CAUTION!
When the device is not in use, protect the
battery contacts. Loose metal parts may
short-circuit the contacts; explosion and fire
hazard!
Battery state of charge
 Press the button to check the state of
charge at the state of charge indicator
LEDs.
16
If one of the LEDs flashes, the battery must
be recharged. If none of the LEDs light up
after the button is pressed, the battery is
faulty and must be replaced.
The indicator goes out after 5 seconds.
NOTE
Follow the instructions for charging the
battery set out in the charger operating
manual.

Inserting/changing the saw blades

WARNING!
Remove the battery before carrying out any
work on the power tool.
CAUTION!
Used cutting accessories may become hot.
Wear protective gloves!
Select a saw blade to suit the material to be
machined. Refer to the manufacturer's
catalogues for details of saw blades that can
be used.
 Open the tool holder lock and press down
(1.).
 Pull the used saw blade forward out of
the tool holder.
 Insert the new saw blade into the tool
holder and push in as far as it will go (2.).
 Close the tool holder lock.
RS 29 18.0