Installation - Alpine XMA-T200RF Manual De Operación

Installation

Installing the Remote Display Unit
CAUTION:
Do not install the remote display unit near the air-bag of
the front passenger's seat.
• Check the installing location.
• Determine the installing location on the dashboard
(in the center, and flat position).
• Installation using Velcro tape
• In case of installing the remote display unit with the
Velcro TM tape attached, cut the tape into two pieces.
1. Without separating the two pieces of Velcro tape,
peel off the paper backing on one side and place on
the back of the remote display unit.
NOTE
Take care not to cover the caution label on the remote display
unit with the tape.
2. Make sure the location selected is free from
moisture or dirt. Peel off the backing paper from the
other side of the Velcro tape on the Remote Display.
3. Place the remote display unit on the installing
location and push the unit to fix securely.
• Installation using flush mount
1. After determining the installing location, install the
flush mount with screws (M2.9 x 20).
2. Insert the remote display unit into the flush mount to
lock securely.
NOTE
To remove the remote display from flush mount, please use thin
plate such as a plastic card to insert to either side of the remote
display carefully. Then the remote display will be released.
Flush Mount (included)
Velcro Tape
Dashboard
Tapping Screws (M2.9 × 20)
(Included)
• Installation using flush mount and
bracket mount
1. Make a hole to match the external dimensions of
bracket mount on the installation location of the
dashboard.
2. Insert the remote display unit into the flush mount to
lock securely.
3. Insert the remote display unit and flush mount
combined into the bracket mount and fix them.
4. Insert the remote display unit, flush mount and
bracket mount combined into the hole made at step
1 and fix them.
Bracket Mount (Included)
Installing the FM Modulator Box
The FM Modulator Box can be mounted to any flat
surface using the Velcro tape.
Installing the XM Tuner Box
• Install the unit
1. Using the unit as a template, hold it at its mounting
location and mark the holes to be drilled. Before
drilling, make sure that there are no objects that
could be damaged behind the mounting surface.
2. Drill holes and secure the unit with self-tapping
screws (M4 x 14) supplied.
NOTE
An antenna is required for the proper operation of this
receiver. This antenna must be purchased separately. The
TUA-T020XM receiver can use any antenna that is designed
specifically for the XM receiver. Please follow the installation
instructions supplied with the antenna.
Dashboard
Flush Mount (Included)
Velcro Tape (Included)
Screws
(M4 × 14)
(Included)
19
-EN