Installation Instructions - GE PVW7301 Instrucciones De Instalación

PREPARE HOOD FOR INSTALLATION
Remove the grease filter from the unit and set
aside. The grease filter is removed by pressing
the handle in front of the filter. When replacing,
make sure that the filter is
properly positioned with the
handles in front and visible.
Vented Installations
1. Securely press the damper
on top of the exhaust opening. Check that the
damper opens freely.
2. Remove and properly discard the protective
plastic wrapping from the hood and grease
filter.
3. Go to Mount the Glass Range Hood section.
Non-vented (ductless) Installations
NOTE: A recirculation duct, extensions, and
bracket are all included with the hood and
are necessary for recirculation installation. A
charcoal filter, not included, is also needed
for recirculation installation. The damper is
not installed on the unit with recirculation
installation.
1. Install the recirculation duct extensions to the
recirculation duct.
2. Attach the recirculation duct mounting bracket
to the recirculation duct using the duct cover
screw supplied with the hardware package.
31-11007-1

Installation Instructions

Attach Using
Duct Cover
Screw
3. Fit the recirculation duct with extensions over
the vent exhaust outlet and push down to seat
on outlet. Attach the vertical duct work to the
top of the hood. Check that the recirculation
duct is in the proper orientation (hole facing
towards the back of the hood).
Recirculation
Duct with
Extensions
4. Go to Mount the Glass Range Hood section.
MOUNT THE GLASS RANGE HOOD
NOTE: If ductless (recirculation) installation,
follow steps 1-6. If ducted installation, follow
steps 1-3.
1. Using 2 or more people, lift the range hood and
place on the hood mounting bracket. Make
sure the bracket fully engages the holes on the
hood body.
B
2. Place a mounting screw into the duct cover
anchor at the center slot provided on the
bottom of the back side of the hood. Securely
tighten.
Mounting Screw
3. Secure the hood to the mounting bracket by
fastening a duct cover screw in hole (B) on both
sides of bracket shown previously
NOTE:
Hole must
be facing
toward back
of hood.
Vent Exhaust
Outlet
Duct Cover
Screw
Hood
Mounting
Bracket
Hood
7