SilverCloud UF41 Manual De Instrucciones página 6

General description:
ú
SilverCloud UF41 Non-contact Infrared Thermometer is specially designed to measure
body or ambient temperature.
Safety cautions:
This device must only be used for the purposes described in this instruction manual.
ú
This device must only be used in an ambient temperature range of 5℃~40℃, the best
ú
temperature is 25℃.
Do not expose this thermometer to extreme temperature environment of ＞40℃ or ＜5℃
ú
Do not expose this device to electric shocks.
ú
Do not use this device in relative humidity higher than 80%RH.
ú
Do not use the device near strong electromagnetic fields such as found with cordless or cell
ú
phones.
Keep the device away from water, heater and direct sunlight.
ú
Do not drop or knock the device and do not use if it is damaged.
ú
Do not attempt by yourself to disassemble ,repair or re design the device.
ú
Mode setting:
ú
Press "SCAN" button to activate the device and at the same time the device will start
measuring the temperature. If the mode is "BODY" last time you used, the LCD maybe
display "Lo"; if the mode is "SURFACE TEMP" last time you used, the LCD will show the
measured result.
Settings
ú
Press button to switch between BODY and SURFACE TEMP (ambient) measuring
mode.
ú
Press button to switch between°C si °F
ú
Hold pressing
Release the
ú
Press button to switch to below functions: back light on, laser on, back light off, laser
off"
ú
Press button to consult memories of to consult saved data of the measured results.。
The memory capacity is 32 results.
Precaution before use:
ú
In order to obtain reliable and stable results, when changing the environment to a room with a
significant temperature difference, it is recommended to leave the non-contact infrared
thermometer to this ambient temperature for 15~20 minutes before using it.
ú
Depending various skin types, thickness and body position there may be different measured
result. This is normal.
ú
Allow 1 minute interval between two measurements.
Features:
ú
Alarm function once temperature is too high. The default threshold alarm value is 37.8℃
(100.04°F)
ú
Automatically save data
ú
Automatically power off in 5 seconds if no operation
button till the screen displays "On" and you hear a confirmation beep.
button. Press again to disable the alarm.
1